20 Most Recent
1989 Mazda 323 Questions & Answers
How do i set timing on a mazda 323 without timing light
I will give you an off record advice as my dad used and sometimes I follow myself. Before starting the engine go by the distributor and loose the two or three bolts might be 12 mm or 13 mm ,- someone else to do the starting- as you are by the distributor start turning it to the side where the engine starts to rev up. You stop turning the distributor soon as you notice the engine started reving up, There you tight the bolts. Switch the engine off and then restart to see whether the engine starts easily and quick.
How to remove fuel pump
if i' not mistaken its in the tank..remove the back seat and you'll find the cover for the sensor remove it you;ll need a phillips screw driver and you'll find the pump directly inside the tank
RADIATOR FAN NOT KICKING IN
You do not need a thermostat for the fan to work but you will need a thermostat for the engine not to over heat. Put simply the thermostat controls the flow of water through the radiator cores so that the heat in the water has a chance to transfer to the cores and fins and away.. NO thermostat =too fast water flow = hot engine.. Fans work off a temperature sensor which tells the CPU when to activate the relay to switch on the fan. Check out the circuit for the fan including the sensor ,fuses, relays and wiring, and fan . Fix it properly so that you can enjoy driving
Air bubbles in water reserve tank while engine is running
Persistent bubbles indicate a leaking cylinder head gasket. To confirm this have a shop with a engine gas analyzer problem the coolant tank and see if any combustion gases (hydrocarbons) are present, if it indicates there are you have a leaking head gasket.
I have replace the clutch on my rustler but it
Bleed the hydraulic system. Check the hydraulic lines, it could be swelling, Did you change the pilot bearing as well? If it was removed and not replaced, there will be a hard vibration.
Not finding what you are looking for?