20 Most Recent 2003 GMC Envoy Xl Questions & Answers


I don't think the piece of rubber has anything to do with the functionality of the latch itself it usually there for keeping the latch quiet like no rattle or metal noise on the road.
Hope it helps

2003 GMC Envoy... | Answered on Feb 19, 2018


Chev is known for injector issues. You may have to remove the intake plenum and change one or 2 of the injectors. You can find them reasonably cheap online. You can test individual injectors with a small square 9 volt battery - never use a 12 volt car battery on electronic components as it's too much amperage.

2003 GMC Envoy... | Answered on Dec 17, 2017


There are almost 1,000 possible trouble codes that can turn on the check engine light. Asking us to guess which one caused your problem is a waste of time. Go to an auto parts store and have them scan the codes. Then post them here. THEN we can help

2003 GMC Envoy... | Answered on Nov 30, 2017


Could be the blower motor going bad.or a wire not getting good contact.

2003 GMC Envoy... | Answered on Sep 13, 2017


mi problema es con los faros de en frente se prenden y se apagan nadamas las bajas porque las altas estan vien

2003 GMC Envoy... | Answered on Jun 10, 2017


have no idea what a needles board is in reference to a GMC envoy . PLEASE enlighten us

2003 GMC Envoy... | Answered on Oct 09, 2016


It is quite likely that the linkage cables have come loose. Remove the rubber boot (cover) and visually inspect the 2 cables. If they appear properly connected, check the connection at the gearbox. This might be a simple matter of re-attaching the cables at some point. If not, you should have it inspected be a professional shop, as it is possible that the internal linkage has come apart.

2003 GMC Envoy... | Answered on Sep 23, 2016


Try replacing the blower motor resistor pack.


2003 GMC Envoy... | Answered on Jun 30, 2016


Ali, when you say won't start, do you mean it will not even crank, or does it crank and does not fire? Sounds like a computer or security issue .
To show your appreciation press the helpful button and follow me on fixya for more tips and info.

2003 GMC Envoy... | Answered on Feb 16, 2016


normally it is the resistor,( relay) then resistor module then motor.
did you test the relay(I believe located under hood, relay/fuse center), If OK check plugs and wires for melting, damage and good connection, grounds should also be checked. Use a volt ohm meter to see if you are getting any power ti motor,etc.
the first link below gives good how to diagnose blower,press the helpful button
GM Blower Motor Resistor Diagnostics by Wells

DIagnose and Replace GM blower Control Module

http://www.gmcproblems.com/tsbs/Envoy/2003

2003 GMC Envoy... | Answered on Jan 31, 2016


Okay, how expensive could this fix be ? The easy answer would be with a question... how long is a piece of string ? There is really no way to tell... But stick with me and I will try to help you, as well as give you the greatest feeling of all. The ability to fix it yourself. This happens a lot to people who are mostly just drivers, not so much mechanics. The P 1515 code and the P 1516 code are both telling you the throttle positioning sensor isn't in the right place for the way the engine is running. Since it isn't running they most likely are just telling you that exactly... You are giving it gas but it isn't revving up like it should. So don't worry about those two yet...Now the P1345 is the Crankshaft/Camshaft positioning sensors telling they are not quite in line as they should be. This could mean it might need a look at the timing gears or chain or whatever it has to keep the valves and the pistons in tune in order to fire and expend the exhaust correctly. Look at your owners manuel and it will tell you how many miles your vehicle has when it is time to have this service done... But first before you do anything else.... Lets look about the P0014....This could fix the whole problem and if it does we will be done. Go out to your vehicle and CHECK THE OIL.... IF IT IS A QUART OR MORE LOW... THERE IS A SAFE SENSOR THAT CUTS OFF THE ENGINE... IT IS FOR THE PEOPLE TOO BUSY TO PAY ATTENTION TO THE STANDARD MAINTENANCE THAT YOUR MACHINE SO SORELY NEEDS... Try this and don't put more oil in it than it needs. This is almost worse than not enough. To check the oil just pull out the dip stick and wipe it very clean.... Then put it back in all the way, and pull it back out carefully, and notice where the bottome of the stick is wet with oil or dry. It will tell you how low it is. Then put exactly enough oil in it to register full on the dip stick. Hopefully this will conclude our troubles and you can be on your way. Thank you sir and good luck to you. Please let me know if it fixes it. If not we will go to the next step....If it does I will give you some tips and secrets to keep your baby going for a long time @_@ I am watching for you..
expensive-fix-could-engine-light-ugh31kwegkjom5czc2ramjjp-3-0.jpg

2003 GMC Envoy... | Answered on Jan 21, 2016


If your settings are correct and the engine is warm, it will be the thermostat.

One other it could be is a cylinder head Gasket. More than likely its your settings or thermostat

2003 GMC Envoy... | Answered on Dec 12, 2015


On the factory radio you need to use the seek (minutes) and scan (hours)...you need to turn the power off to the radio only...Press clock button, then move up and down using seek/scan...Should be in your owners manual too. Hope this helps.

2003 GMC Envoy... | Answered on Jun 02, 2015


Try tapping on the Throttle Position Sensor, you may need a new one.

2003 GMC Envoy... | Answered on May 07, 2015


No your car will still turn on with a bad cam sensor. Bad crank sensor would cause a no start. What code is popping up with the check engine light?

2003 GMC Envoy... | Answered on Feb 28, 2015


Sounds like you may need a tune up. It could be a restricted fuel filter or old fouled out spark plugs. The possibilities are huge. Your fuel pump could be weak or you have a bad or leaking injector, but start with the simple stuff first if you haven't done a major tune up in a couple of years, start there. You could also do a fuel pressure test to be sure your system he enough pressure before you spin it over.

2003 GMC Envoy... | Answered on Jan 19, 2015

Not finding what you are looking for?

418 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2002 GMC Envoy XL
2002 GMC Envoy XL

112 Questions

2004 GMC Envoy XL
2004 GMC Envoy XL

15 Questions

2005 GMC Envoy Xl
2005 GMC Envoy Xl

170 Questions

2006 GMC Envoy Xl
2006 GMC Envoy Xl

116 Questions

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85111 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Envoy XL GMC

  • Envoy XL GMC

Most Popular Question

envoy intermittantly starts missing goes

  • Cars & Trucks
Loading...