20 Most Recent 1995 GMC Sierra - Page 9 Questions & Answers

was not getting fuel replaed fuel pump and all filters still want fire and am getting fuel to carb
have tbi fuel system was running good 195gmc sierra 5.7 l auto trans

you need to check the codes with an OBD 2 reader.
once you get the codes that will steer you in right direction.

the brake master cylinder reservoir is located on the drivers side of the engine compartment near the firewall right above and mounted to the top of the brake master cylinder. I believe that one should be a yelowish color with a black rectangular cap that measures about 3 inches by about 5 inches. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Have you checked to see if it is firering also because if the ECM goes out it will restrict the fuel injection system and make it seem like its the fuelpump and it will also restrict the fireing.

2 locations it would be. The first is under the dash on the passenger side of the vehicle and the second (I think this is where yours is due to it being a 1995) would be in the engine compartment on the passenger side firewall is a black cover for fuses and such. There are 3 plastic nuts to remove the cover. In both locations you are looking for a tan wire with a black stripe. Just to make sure you know the proper timing procedure; after you unplug the bypass you time it to 0 degrees (dead on in other words). Shut off, plug back in, restart and don't give it a heavy load just give it gentle acceleration don't drive it hard. I hope this helps and good luck.

check fuse or get test light and poke motor wires while pushing button if it lights up and motor doesnt work then bad motor no light means no power

IGNITION SWITCH IS FAULTY NEEDS RENEWING

are you sure its the starter?or any other unit.

All you have to do is reach up underneath the rear bumper, grab the light socket and turn a quarter turn counter-clock wise and pull the socket out of the housing. Then firmly grab the light bulb and pull straight out. Just reverse these directions for replacement.