20 Most Recent 2004 GMC Sierra - Page 3 Questions & Answers

Sounds like bad door switches. Can be a bad module as well.

Scanned ?? Code(s) stored ?? If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

No.....Sealed Assy.... If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

1 Scan/ck for code(s) 2 With scanner connected,road test vehicle/ck scanned parameters If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

Origional size tires wheels ?? If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

Flush the oil put a detergent in to the engine add oil flush again and change the sensor for the oil pressure

to gain access to it by the glove compartment remove two screws then pull up ... do reverve to install the new one. hope it helps

I would start by taking it apart and drying it out, but there may be damage to the electrical components.

Most likely is your temperature control panel.These go bad often.But is relatively easy to replace. But if you are unclear of what I am talking about it's the panel that has the knobs on it that controls the fan.

Other than watch a You Tube Video, on any similar axle housing ? Remove the rear cover,bolt,cross shaft pin,push axles in,remove c-clip & pull axle out !!

should be a plastic clip to pop it into

burnt bulb. Pain to change. Unless someone cut wire to turn it off.

It could be a leak in your vapor hose or you may need to replace your condenser.

if your car will not start. then try trun the key on do not try and start it just trun it on let it set for about 10 to 20 min.s then trun it off and try to start it. should reset the computor.