20 Most Recent 2001 Dodge Dakota - Page 9 Questions & Answers

The light will cut off, it might trigger a worming light on your dash

check ground locations in harness under hood ,make sure they are tight

The driver's door has a control panel with switches to control 2 or 4 windows, above those are two switches - the one closest to you is the power door lock and the one away is the window lock button. The image below has a red arrow pointing to the switch. Good luck!

Chrysler car solonoids products that use electricity inside the oil pan regularly can usually be removed and cleaned and they will work again. They tend to get sticky if laquered up and move unserved regurarly. This happenes from neon all the way up to dodge 3/4 ton pickup with a gasoline engine. your car pretty good but I think you should go and check the ingredients used stable fit your vehicle.http://www.hopy1.com

go to junk yard and get ecm and change out

You need a chiltons guide for your vehicle, check wiring diagram. Possibly 2 wires go together. If you need further help, reach me via phone at https://www.6ya.com/expert/frankie_091f536560a54e12

Code p1762 is the governor pressure offset volts too high or too low. This is a transmission solenoid that probably needs replaced. I believe that you have to take the pan off to get at it.

Take the oil pan off, and it will be sitting there staring you in the face. Look at the replacement and see where the bolts are that hold the pump on. Remove them, take old pump out, put new one on. DO not overtighten the bolts. not a tough job, but very messy. Best to let the oil drain overnight after oil pan is removed. You will also need anew oil pan gasket

check your fuses for wipers ,

on the intake should be gray in color 2 wire connector think driver side of pleanum close to top

well first take off the door panel it shouldnt be hard remove plastic cover off door.Make sure your window is all the ways up before you remove the motor.you can hold it up with duct tape or anything similar.Then remove the screw that go to the regulator sometimes it has rivets wich have to be drilled off.The new regulator should come with screws if it has rivets if not u use the same old screws.Also unplug the harness of it . Install new one,screw it on and reverse the procedure.Any problems keep me posted

The warning lights are on because the abs system is disabled. You would need to scan the computer for trouble codes then fix the problem to keep the lights off.

Does it do it if you disconnect the idle air control valve ? You need to know if its a vac leak or if the computer is making the valve open too far.

impossible to work out . check to see if there is a application that doesn't have the compressor in the system and get that belt ( good place to start is at your car spares department to see if such a belt is listed) Alternatively take a flexible tape measure and wrap it around the pulleys you want to use and read the distance . It will be a starting measurement and when you buy the belts ensure that you will be able to exchange the belt if it doesn't fit

take your glove box off and its right in front of you 2, 8m bolts