20 Most Recent 2004 Mazda RX-8 - Page 9 Questions & Answers

try driving it around the block or down the street then stop, turn off engine then start up again. should reset after that

Believe it or not this is a very simple problem to solve. The face plate for the center control unit has small black plastic studs with female threaded inserts pressed in them that the radio hed unit is screwed into tho hold the entire unit together. My daughters 04' RX8 display was going on and off when she would hit a bump. I followed instructions of you tube video titled DIY:OEM Radio removal first gen RX8 6mt. It is very detailed and step by step. When you get to the last step which is pulling out the complete unit be careful as this is where I am sure you will find what I did, The face plate will be loose on 1 side or both. On Mine it just was one side and I almost broke the black molded plastic studs on the back of the face unit on the other side. You will see the screws with the inserts still screwed on to them where they have pulled loose from the black studs. I used epoxy to reseat them into the studs, reassembled the unit and reinstalled. I have had no other problems.

That's a lot of things out! I think you need to check to see if there is a large fuse blown (Maxifuse) in the underhood panel,or maybe you accidentally unplugged something by accident while charging the battery.

check your fuses in your fuse panel inside your engine bay.

possible fuel pressure issue, try replacing fuel filter and putting injector cleaner in your tank.

Duplicate question.

20 to 25 mins as they are at a hard angle to get at it be easier to take your passenger wheel off and going through wheel ache

needs new red top battery and a new nz1 starter motor

there is a sensor in your headed tankthat is what is causing is light to come on either clean sensor or a new headed tank that should take it off

These are transmission control module can communications codes. ealer will need to repair these for sure.

look there is no spare parts for the powersteering bump but before any things you should check the powersteering bump belt if it ok or if it need to tension . other wise you have to change the bump

what code ,

See a dealer for thatNo one on the internet would or shouldhave access to radio codes or other security issues. Think about what your asking