20 Most Recent
2004 GMC Canyon - Page 6 Questions & Answers
How to replace foglight bulb
Reach behind the fog light from under the vehicle and grab the connector on the back of the light housing. Twist it 1/8 turn counterclockwise and remove the bulb. Remove the power connector on the back of the bulb. Install new bulb and reinsert it into the housing. Give it a short twist to lock it in position.
Remove alternator
Hi Friend:
To remove your Alternator.
#1) First disconnect your negetive Battery Cable.
#2) Then you'll need to get a Breaker Bart or a Rachet and Socket,To take the Pressure off the Serpitine Belt by using the Ratchet and move your Belt Tensioner to remove your Alternator Belt.
#3) The tensitioner is and Alumium Part with a a Pulley on it ,thats keeps pressure on your belt.Move it both left and right until you see which way it loosens tension.Then While Tension is off your Alternator Just reach over and Pull belt Off.
#4) then un-plug and Disconect the Wiring going to your Alternator(NOTE) Mark your Wiring so you get it back on the way it comes off.
#5) Then you'll have 2-3 Bolts Holding Alternator in place ,Just Remove them And your Alternator will come Off.
#6) Take the Old Alternator to Parts Strore and Have them Test it,Just to Verify its Bad. And By taking it you'll save an extra Trip because they'll want your Old Alternator as a Core.
#7) Plus you can match the Old with The New to Make Sure They are Selling you the Right One,
I Hope this Helped you Please Let me Know by Voting on the help i've given you,Thank You for Using FixYa From: d_hubbs
Abs fault light comes on
If you start the vehicle and the ABS light never goes out it is failing its self check test. Typically a bad wheel speed sensor will cause this.
If the light comes on when you start it, goes out shortly after, but comes on after driving for a little bit than the problem may be a little bigger. Wheel speed sensors could still be the problem but you could also have issues with wheel bearings, exciter rings, solenoids, or modules.
The best thing to do is have the ABS module scanned for codes. This will narrow down the possibilities significantly. Post the codes here and we'll be more than happy to guide you to the next step. I’m happy to assist further over the phone at
https://www.6ya.com/expert/jeremy_d728a59f986299fa
About 3 weeks ago i was getting a code for the MAF
I'm going to go out on a limb and sugest that you look for melted wires in the engine compartment. That would explain the burning plastic smell. And a bare wire grounding on your engine could cause about 100 diferent problems.
Air bag light stays on GMC 04 cayon
You will have to get the codes from the Sensing Diagnostic Module(SDM).This will tell you what could be causing the problem.Hope this helps.Good luck.
02 sensors
as long as the light is still on the ecm thinks there is still a problem. did you turn of the light with a obd2 scanner. if not go to any auto parts store and they will turn light off for nothing. just tell them you just replaced both sensors. hope this helps!
I replaced my brake rotors on a 2004 gmc canyon
IF you installed the wrong brake rotors,without the ABS reluctor ring[if equipped],the light will come on.Second possibility is you damaged the ABS wiring to the wheel speed sensor.There is a harness to each wheel.
Have to replace bulb on
Just go under the rear bumper and disconnect the electrical connector and remove the nut holding the license lamp and remove the lamp assembly from the bumper.Twist the lamp socket counter clockwise to remove the bulb.Then just reinstall the bulb,socket and lamp assembly on bumper.You might want to check and make sure it works before you reinstall it.Hope this helps.Good luck.Let me know if you have anymore questions.
Not finding what you are looking for?