20 Most Recent 1999 GMC Sierra - Page 2 Questions & Answers

What size engine ? As this vehicle could have come with four different one's. 5.0 , 5.7 , 6.5 and a 7.4 L

You can go to an auto parts store and purchase a manual for your vehicle.

I'am going to go out on a limb hear and assume that you need this due to the fact your tail lights quit working. This is a very common problem, and the circut board in the tail lamp seems to be the main problem in these. Most parts stores carry these at all times. If you need for other than this problem- please clarify

If the Pontiac engine is similar to the small block Chevy, you have, I believe, a hexagonal shaft that runs from the end of the distributor shaft down to the oil pump. This is turned when the distributor shaft is turned by the meshing gears on the camshaft and distributor shaft. I would say that you are probably going to have to re-time the engine. Find TDC, then replace the distributor. It won't matter a whit to the oil pump if the gears are one or two teeth off, but it will matter a great deal if you distributor is not installed so it can be adjusted a few degrees when you get to "fine timing" the engine. You should be able to download information on how to time the engine (finding TDC, etc.). Failing that, a trip to the library may be in order.

171 code bank one lean 174 bank two lean
possible vaccum leak

The Internet, though, has a large number of web sites where you can buy service manuals and schematics from bookstores, publishers, and other collectors. Here is just a sampling of what sites are out there: Factory Auto manuals http://www.factoryautomanuals.com/ search for : factory service auto repair manuals Repair Service Manuals http://www.repairservicemanuals.com/ the largest collection of Automotive Repair Service Manuals and Owners Guides on the internet. Our database currently holds over 54,000 entries dating back from 1940 to more recent 2011. about Chilton Repair Manuals http://www.chilton.cengage.com/ about Haynes Repair Manuals Haynes Publishing Haynes auto manuals http://www.haynes.com/

The speed sensor is on the output shaft of the transmission. Either it was damaged or not hooked back up.

the power to what switch?, Ignition?, window switch?, sunroof switch?. Please be more specific with your details. This will help us to give you more professional advice.

clean the EGR valve and also the idle control motor valve

My info says, under the vehicle, driver side, close to gas tank, attached to inside frame rail. If you lay on the ground, passenger side, look at the inside driver frame rail, you can probably see it. Make sure no pressure on the fuel system before taking any fuel lines loose.

The clutch packs for 3-4 need replacing this is a common problem with 4L60E transmissions. The vehicle should be driven D1 any time that you are traveling under 50 mph or 80 kms.

See this video: https://www.youtube.com/watch?v=oO0T1nJdamY I found this in seconds when doing a Google search. Not sure why you could not.

http://s648.photobucket.com/user/chau8238/media/99BRB.gif.html (Shows location very clearly. Found it using a Google search. You could have done it too, saving me some time! Don't forget, we don't get paid for this.)

Mass air sensor could be bad causing the wrong air to fuel mixture. It's a cheap and easy replacement to try first.

check for spark wires for distributor may have got pinched between trans and engine If you need further help, I’m available over the phone at https://www.6ya.com/expert/mike_9693b5ad75773352