I can not find my fuse box diagram for my 2002 f250 super duty... Help...
For Ford's fuse diagrams and schemes you may want to check Ford diagrams schemes imgVEHICLE com
Posted on Sep 26, 2018
My 99 F350 supercab 4x4 with 7.3 diesel and 6 speed has a bad vibration. Does not matter what gear I'm in, and seems to be even worse when downshifting and letting the motor hold the truck back. It seems to have a constant vibration from 30-40 but a violent shake from 40-45. The truck has 129,000 on it, I just put on new tires approx 300 miles ago and it had no effect on the vibration/shake as it is still there just as before. I replaced the carrier bearing, all u-joints, and front section of rear driveshaft almost 5 years ago at approx. 60,000 miles. Does not matter whether loaded or not, towing or empty. Happens in 2 wheel drive with the hubs unlocked so I know it has to be in the rear somewhere. Any ideas or should I start with another new carrier bearing and u-joints in the rear? Also, how much should I be able to move the carrier bearing in the rubber when I crawl under the truck and move the driveshaft up and down? Thanks.
The carrier bearing should not move at all. It is mounted in rubber to give a little. But, it should not move freely. If this is the case then something has gone bad. The carrier bearing would cause this vibration as it spins if it is loose.
Posted on Mar 16, 2009
I need to service the ac. I need the weight of how much the system holds, and where the low pressure valve is located.
Hello, I see you are trying to charge the ac on you truck ,but this is not a job that just anyone can attempt and get it right. You must add factors in like is there the right amount of oil in system, is there any freon already in the system, or will there need to be a vaccum pulled on the system. If the system is completely out you must pull a vaccum for 30 minutes on the system, or either there will be moisture in the system and that can do alot off damage to an ac system. If you have never charged an ac system please let take it to someone who has. It will save you in the long run and if it is leaking they may find it as well.
Posted on Apr 07, 2009
truck will not start today,it worked perfect yesterday but today when you turn the key on all the gauges go crazy,flip back and forth so on.and theres a clicking sound but the starter wont turn over
I have a 1999 f-250 super duty, v-8, it was good all day the day before, yesterday I was going to drive it to town, would not start, power is good, lights come on, turn key no response.
Posted on Nov 07, 2010
2002 F250 - Location of fuse for Trailer ''+'' feed
I wish I could help you more than this, but the fuse you are looking for will be int he fuse box in the engine compartment and is a 10 amp fuse.
Posted on Jan 06, 2010
head bolt torque for a 5.4l ford triton
To install: Fig. Tighten the cylinder head bolts using 3 steps in this sequence-4.6L and 5.4L engine
NOTE
To correctly tighten the cylinder head bolts an angle torque wrench is needed.
WARNING
Cylinder head bolts must be replaced with new ones. They are torque-to-yield designed and cannot be reused.
NOTE
Be sure to tighten the head bolts in 3 steps.
Heater hose.
Exhaust manifolds.
Timing chains.
Intake manifold.
Cylinder head covers.
Electrical connections and cables.
Refrigerant.
Engine oil.
Coolant.
Negative battery cable.
Posted on Jun 02, 2011
Where is the compressor clutch relay f25O 2002
The relay is under a black plastic cover on the driver's side behind the battery. There are a couple other relays under there.-------I would start by jumping the AC relay to see if the clutch will run, you do this by removing the relay and putting a jumper wire between 30 and 87 terminals, if the clutch runs then check to see if there is power on the 85 terminal at the relay and a ground at terminal 86 if all are good replace the relay. The terminal numbers are located on the bottom of the relay, be sure that terminal 30 has power if the clutch does not run. This will solve the
problem or point you towards the cause of problem. Thank you for using fixya.
--
Faulty compressor clutch relay. Check to see if the relay is receiving voltage when the A/C is turned on. Also check the relay wiring and ground connections. If bypassing the relay with a jumper wire or routing battery voltage directly to the compressor clutch makes the A/C work, the relay is probably bad.
-------------
Posted on Jul 01, 2011
fuel relay on a 2002 f250 super duty, no manual
Regards,
Tony
Posted on Oct 16, 2011
Need wiring diagram for radio in f250
Most Chilton service manuals include wiring diagrams. Check for diagrams before you buy. murf427
Posted on Aug 02, 2012
where is the turn signal fuse located on the 2002 ford f250
There are two fuses, a 20amp marked F2-13 and a 10amp marked F2-23. They are in the central fuse box which I think is under the speedometer.
Your owners manual will have the details.
Posted on Feb 28, 2013
1,473 questions posted
Usually answered in minutes!
705 Questions
546 Questions
442 Questions
465 Questions
399 Questions