20 Most Recent
1995 Ford Explorer - Page 9 Questions & Answers
Fuel Guage
The sending unit in the tank is bad or is not positioned properly.
10/26/2012 6:02:05 AM •
1995 Ford...
•
Answered
on Oct 26, 2012
How do you bleed the pressure off the fuel line on a 1995 ford explorer
use a piece of small rubber tubing to depress the valve in the fuel rail and drain the gas into a suitable container- OR- shut off the fuel pump by pulling the fuse or using the fuel pump emerg. shut off switch- then just start the engine and it will run out of gas in about 20 seconds- Presto - you now have no fuel pressure...
10/26/2012 5:57:24 AM •
1995 Ford...
•
Answered
on Oct 26, 2012
EGR pressure sensor
It is on the driver side of the air intake manifold- just above the valve cover between the throttle body and the PCV valve.
10/26/2012 5:47:37 AM •
1995 Ford...
•
Answered
on Oct 26, 2012
95 ford explorer that keeps burning out fuel pumps
Are you sure your shop is putting in a quality pump and not some kind of crappy remanufactured part? You should have no problems with an OEM quality pump...but some of the cheaper generic pumps will not last very long.
10/26/2012 5:44:34 AM •
1995 Ford...
•
Answered
on Oct 26, 2012
WHERE IS THE INLINE SPOUT CONNECTOR
right between the front of the battery and the rear of the driver side headlight under the wiring harness that goes to your ignition control module. It is pretty well hidden...
10/26/2012 5:38:42 AM •
1995 Ford...
•
Answered
on Oct 26, 2012
Gas gadge wont work
One of the sender wires is broken off- usually near the pump on the top of the fuel tank..
10/26/2012 5:35:29 AM •
1995 Ford...
•
Answered
on Oct 26, 2012
How to tune up 95 ford explorer
It couldn't be much easier, change the air filter, clean or replace the spark plugs and you r good to go...the timing is all electronic and non-adjustable.
10/26/2012 5:29:13 AM •
1995 Ford...
•
Answered
on Oct 26, 2012
1995 ford explorer check engine light is on
Get a shop to read the codes from the engine computer. You can do it yourself by grounding a pin on the diagnostic connector and counting the flashes from the check engine light. The code will tell you which part is causing the problem- usually an oxygen sensor or an EGR problem on these engines.
10/26/2012 5:27:10 AM •
1995 Ford...
•
Answered
on Oct 26, 2012
Not finding what you are looking for?