20 Most Recent
2005 GMC Canyon - Page 5 Questions & Answers
Engine light came on
This could have been a result of not securing your gas tight enough. Check your manual, if it persists have it checked for the engine code fault.
How do I correct a dim headlight?
This is caused in most cases by a poor headlight ground to the body of the car, find and clean the ground, it is near the head light under the hood.
Wheel alinement 2005 canyon
Alignment Shops ( not some chain store place)have reference material & update bulletins- for allvehiclesThere are alignment kits,parts & proceedures for everyvehicle.Not from the factory in most cases,but the aftermarket.No such thing as can't align, unless you need body shop involvement or have damaged parts
Brake lamp switch
If you have power going to your lights then the problem is earth connections to complete circuit
How to clean throttle body on 2005 gmc canyon 3.5l
This problem
is commonly caused by a dirty automatic idle speed control valve and
throttle valve. Buy a can of throttle valve cleaner (do not use
carburetor spray cleaner!) from NAPA or Carquest (made by CRC
chemicals) and spray it into the air intake while the engine is
running, use up about 1/2 the can, engine will try to stall hold the
speed up, shut it down and let it soak for 30 minutes, restart and
blow out the remaining fluid, shut it down and disconnect the
negative battery cable for 5 Min's to reset the base idle control
Abs light comes on says fault traction
One or more of your sensors is going bad at the wheel. Usually in the hub. You can go from wheel to wheel and unplug the lead wire and figure out which one it is.
How to replace rear wheel seals
remove the rear diff cover remove the rear brake drum/rotors rotate the rear driveshaft until you can see the bolt that holds the center pin slide out the center pin push the rear axle in and remove the c-clips then slide the axles out reverse to put back together then add fluid
Not finding what you are looking for?