20 Most Recent 1998 Nissan Pathfinder - Page 4 Questions & Answers

como puedo desactivar la larma de la nissan pathfinder 1996, siempre desactivaba metiendo la llave de la puerta del conductor y giraba al derecha pero ahora no desactiva alguien me ayuda por favor muchas gracias

i have had the same problem whhat i did was take off the wheels cleaned everything with break cleaner then ssprayed some in the brake cilinder and has worked fine for me

If it is similar to Quest, the fuel pump runs for 5 seconds when you turn the key to ON. Then, unless the engine is running, the pump shuts off. It runs when the key is in START position though. Can you hear the pump run for 5 seconds when you turn key to ON? Listen carefully for the hum of the pump in the tank.
Normally, the power relay powers up the PCM and it applies power to the fuel pump relay. Then you get power to the pump.
Also, look at owner manual for all fuses that apply to fuel pump system.

12 Volts has been a battery standard for as long as I can remember.Do you need to replace your battery? If so go along to a parts place and they can get you the right one. If not your question is somewhat vague,and I am not sure what you might be asking.

Try going to your local Autozone store and ask them to check your vehicle for emissions and other engine problems. This is a free service. They will show you a print out of the probable causes of the problem you are having and the cost of the parts you need to fix your vehicle.

I don't know about your exact make, but every bench rear seat bottom I ever messed with removed as follows: Get your fingers under the bottom of the seat cushion, and give a sharp tug upwards. It should be held in by spring clips, which will release with the upward tug. With the front of the seat cushion slightly raised (so the spring clips can clear the brackets), it should then pull straight forward and out. To re-install, push the cushion back under the seat back (with the front slightly raised), and with both hands, give a sharp push downwards to latch the spring clips.

Possible motion sensor could be windy and it would go off.

the dealer has a code to do this. but you`ll need to prove with id this is your vehicle. keeps bad people honest also and protects you.

Try new coil wire. Also try starting with hood up and in complete darkness. You want to watch the distrubutor/cap/wires areas for arcing through boots/wires etc. Verify you are getting air to your cylinders too. Compression check. Good luck. No starts are No fun!

Check the ignition coil and coil to distributor wire.

Try locking and unlocking the driver door with the door key a few times

Timing Belt Broken ?