20 Most Recent
1994 Nissan Sentra 4-Door - Page 7 Questions & Answers
When i drive my car it sputters and looses power
Hello Jhz.
When in overdrive the engine is under a lot of strain. Combine this with lean fuel mixtures in vehicles today and that is when you need the most spark.
So what I am getting at is that you are experiencing misfire.
This could be caused by a lean fuel injector, poor spark plugs, bad ignition wires or a bad ignition coil.
Why doesnt my car go
if you have an automatic gear box , then it is very possible that you have reverse band is broken inside gear box , , light will come on because switch for reverse lights may be actuated by shift lever not gears .
there is a foward band and reverse band in auto gerabox's so if you are able to drive forward this gearbox will need to be repaired or replaced .
if manual gearbox , you may find a reverse linkage loose , or gears dammaged in gear box .
good luck hope this helps
My gearbox wont select 5th
my suzuki baleno 2001 mod manual has a problem with the gear box. i can go 1st,2nd and 5thgear but can not get in to 3rd and 4th gear...what do you think it could be? thanks my email is:
[email protected]
1994 nissan sentra # 4 cylinder is not working it
check this out i have the same problem i change the sparkplug thinking that maibe it was that or but no same as yours wire have good spark injector is working so two good old neibor hood mechanics check and told me that the enginehead has a broken or bend valve so that could be the problem when a valve is bend or broken it leaks the compretion so thats why that piston dose not wrok .so that problem can be fix by sending engine head to machineshop to replace broken valves and parts or replace engine.
Thermostat replacement 1994 nisan sentra 1.6 eng
JUST DRAIN COOLANT LEVEL BELOW THE THERMOSTAT. CATCH COOLANT IN A DRAIN PAN UNDER RADIATOR.THEN REMOVE RADIATOR HOSE FROM THERMOSTAT HOUSING ON THE CYLINDER BLOCK.THEN REMOVE THERMOSTAT HOUSING AND THERMOSTAT.CLEAN THERMOSTAT HOUSING SURFACE AND THERMOSTAT HOUSING SEALING SURFACE ON CYLINDER HEAD.INSTALL NEW THERMOSTAT IN PLACE,MAKE SURE THERMOSTAT AIR BLEED HOLE FACING LEFT SIDE UPWARD ON THE ENGINE.SOME THERMOSTAT HAS TOP STAMPED ON IT.MEANING MUST BE FACING UP.WHEN THERMOSTAT IN PLACE.TAKE NEW THERMOSTAT GASKET.PUT SEALER ON BOTH SIDES OF GASKET.THEN.PUT GASKET ON THERMOSTAT HOUSING.THEN PUT HOUSING IN PLACE TORQUE HOUSING BOLTS 16 - 20 FT LBS.WAIT 1 HOUR UNTIL GASKET SEALER CURE.THEN FILL UP COOLANT SYSTEM.BLEED COOLANT SYSTEM AND CHECK FOR LEAKS.
Does the clutch on a
Yes, there is a switch on the pedal, just like on the brake pedal of automatics. There are 2 locks, yours is electric, but the key lock is manual, it has to be on. Which it would be if you were trying to start it, but on the automatic, it goes from the key to the shifter with a mechanical lock, also the brake pedal is wired into a solenoid on the shifter, won't move without your foot on the pedal. Sometimes it has to be in neutral to start. Check it out.
I have a 1994 Nissan Sentra, It stalled on the
It takes more then fuel pressure for the engine to run. First thing to do is check the injector fuses and visually inspect the wiring. If that checks out OK use a noid light to see if the injectors are firing. If they aren't firing there is a bad sensor, bad injector driver in the computer or a wiring fault.
Where can i locate the starter
Hi,
Remove the air intake hose from the air cleaner assembly. Remove the clamp and then pull the hose straight off the assembly. Remove the wing nut securing the air cleaner by turning it counterclockwise by hand. Remove the air cleaner.
You will Locate the starter motor directly below the air cleaner assembly. Disconnect the wiring connection on the starter motor. The plug should pull straight out from the connection. Remove the nut securing the starter wire using 13-millimeter socket and ratchet and remove the wire.
Have a nice day
1994 nissan sentra drivers door wont open from
Here's a trick I learned from a local body shop where I live.
Get a sawzall and cut the post that the latch hooks to.
This will open the door for you. Then repair whatever is required in the door, and replace the post on the inside of the body is cheaper than damaging anything else in the door.
Good luck on this repair.
Not finding what you are looking for?