1992 Nissan Sentra 4 Door - Answered Questions & Fixed issues

How to wire ga16 brain box

when the last time you made a tranny oil change ? or also check the level of oil when all that is done youncan get more technical lets see could be the shift bushing ... easy to install and if its a tranny probleme well maybe time to get that corvette you always wanted go big or go home ahahah good luck

Write your answer...Hi I'm driving 96 200sti Nissan sentra but the performance its not good when it cames to a steep slope it reduce the speed but i think its due to timing

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

It sounds like the starter. Take a rubber mallet or a small hammer and beat the starter a few times not really hard like it owes you money, but hit it good. If the car starts after this your starter is stuck and needs to be replaced. Now this might not work, the starter can be so bad that nothing like this will help. Take it off go to your local parts store and they can test it for you. There should not be a fuse anywhere on the starter wire. O yeah make sure the battery is good and charged up. A low battery will do this too.

Pull the handle as if the seat were installed and you were going to move it forward or back. They will slid back and forth on the seat so you can align the holes. set both sides even once you get the correct line up. After you put in front or rear 2 bolts then slide seat to install the other 2. Hope this helps Mike

check for fluid leaks at hoses , pipes and brake callipers and cylinder units. Pull the vacuum hose off the booster and check for brake fluid in the hose. (wet). Repair the fault-replace calliper leaks, replace wheel cylinders , replace brake lines and replace the brake booster. Fill with brake fluid and bleed out starting at the longest line first and finishing at the shortest.

Broken

get a tool called an "easyout" this will include a drill dit and various size threaded cores that are screwed into the hole you've drilled into the plug/bolt etc , the trick is these cores have a left hand thread so turn anti-clockwise to screw in tight, as they are tapered , once tight unscrew clockwise and out comes the offending bolt/plug etc , these tools are available online and are very cheap considering the money they save you on this type of stuff

fuel/ignition or emissions control issues..check these..one system at a time..

87 octane (regular) in the United States, except in very high mountain areas, like the Colorado Rockies. If you live in such, ask a local garage or dealer.Be blessed.

I only run 89 and higher.

1995 Nissan/Datsun Altima 2.4L SFI DOHC 4cyl

The Ignition Timing20 Degrees

my 1992 nissan sentra will not start. It will trun and turn but will not start. when it does start.It missing alot and turn off very fast then it just turns but won't start

Here's a link.

Its faulty blower motor resistor. The low and medium speed on blower motor is controlled by resistor and its actual speed is high. So because resistor is not working, blower motors actual speed which is high is working.

It can be faulty blower motor or faulty blower motor resistor. Get the blower motor inspected. If it's faulty it has to be replaced.

=======

For blower motor testing and replacing, check the link below: ----

Blower motor Testing/replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html

------------

These will help.

Thanks.

The that cylinder is dead.

CONNECT THE WIRES TO THE BATTERY THEN CLIP THE LIGHT TO THE # 1 SPARK PLUG WIRE START YOUR CAR YOU SHOULD GET THE READING

This isn't the most detailed picture but it will give you a good idea as to its location. Hope this helps....

http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?fromSearchPage=true&pageId=0900c152801ce53e&partName=Fuel+Injector&partId=0900c152801ce53e Click on link on how to remove fuel injectors.