20 Most Recent 2000 Mazda B-Series Questions & Answers


At this website www.reliable-store.com I found so much of information on how to repair vehicles
and technical issues in detail.. Also complete, much better language, and they also have live assistance feature

2000 Mazda... | Answered on Mar 07, 2018


look under truck and see if anything is wrapped around drive shaft also if looks good u joints may be going bad also check the center bearing and bracket its a support hanger bearing for driveshaft

2000 Mazda... | Answered on May 24, 2016


Hello, If your engine does not overheat after you have driven it for ten minutes, you installed it correctly.

2000 Mazda... | Answered on Apr 20, 2015


  1. Disconnect the heater return hose at thermostat cover. Disconnect ECT sensor and water temperature sender unit. Disconnect the upper radiator hose from the outlet connection. Remove the bolts. Pull elbow away from the cylinder head. Remove the thermostat and gasket.
The thermostat cover casting contains a locking recess into which the thermostat is turned and locked.
>
Do not use more than 15 - 20 ft ibs to tighten the thermostat housing bolts.


I’m happy to assist further over the phone at https://www.6ya.com/expert/uttamjeet_2f3adc18600f8ede

2000 Mazda... | Answered on Mar 30, 2015


you need a cerpentine belt tool. check out all the pulleys and you will find that one has a square hole in the bracket holding the roller. that arm is spring loaded to maintain tension on the belt. Its not easy for the first time to do this job. The route the belt goes will be on a sticker diagram somewhere under the hood. sometimes they are on the under side of the hood, while sometimes they are on the car's grill frame. it is usually best to put the belt on all the pulleys except the alternator, then pull the tension pulley arm to facilitate the belt slipping onto the alternator pulley. Do not attempt to put it on the tension pulley last. and be careful the tension pulley tension can give you quite a severe pinch if you get your fingers caught under the belt.

2000 Mazda... | Answered on Jan 07, 2015


Check your power steering fluid, it might be low, and causing shudder due to air in the lines.

2000 Mazda... | Answered on Oct 18, 2014


You could have a windshield that is leaking water. Often this water will trickle down from the bottom/inside of the glass and then down the firewall, under the carpet or floor mat, and to the floor. The way I usually hunt for these is to remove the floor mat or carpet then get a flashlight and lay down in the cab so you can see under the dash area while someone sprays water on the vehicle with a garden hose. Often the leak will show up as a trickle that you can then backtrack to it's source. Another spot to look for is at the cowl in front of the windshield where air for the heater and a/c is pulled into the passenger compartment. The water drain holes in this area can plug up and allow water to overflow into the passenger compartment. Good luck, hope this helps!

2000 Mazda... | Answered on Oct 12, 2014


I think the clutch is not releasing, so you probably still have air in the system. Try bleeding it again.

2000 Mazda... | Answered on Sep 25, 2014


This is not a question.

2000 Mazda... | Answered on Aug 31, 2014


check your fuses ecm memory fuse is blown .

2000 Mazda... | Answered on Jun 02, 2014


The problem is a dirty switch. use a can of wd-40 or equivalent and spray the door latch heavily. Next hold up on the door handle and work the latching mechanism back and forth really fast. Next repeat the process 2 or 3 times. It only takes a few minutes and your door latch sensor will be working like new again.

2000 Mazda... | Answered on Apr 25, 2014


Duplicate question.

2000 Mazda... | Answered on Oct 04, 2012

Not finding what you are looking for?
2000 Mazda B-Series Logo

71 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Mazda Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

B-Series Mazda

  • B-Series Mazda

Most Popular Question

truck started making bump noise driving

  • Cars & Trucks
Loading...