20 Most Recent 1995 GMC Yukon - Page 4 Questions & Answers

Hi , Yes it could be just that easy by replsacing a bulb or fuse. In some cars there is a black box that controls the running lights.$$ to replace. There always is an easy fix if you know where to look.

Check for crossed wires or improperly gapped spark plugs.

Hi gregory:On 1995 GMC Yukon 5.7 liter V-8 VIN "K"Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa, have a nice day.

The MAF (Mass Air Flow) sensor measures the volume of air going into your engine. Unfortuneately your 1995 Yukon does not have one. It uses a MAP (Manifold Absolute Pressure) sensor. This measures the difference in pressure between the outside air and the air in the in intake. It hold be mounted on a bracket towards the rear of the engine on the passenger side by the distributor. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com! I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

I don't know if Yukon's had this problem or not, but once I changed a fuel pump on a Chevrolet Blazer only to find out that then the ignition switch went bad. I changed out the ignition switch and it started fine after that. Please rate my answer so I get my points for it.

Check your fuses must have power on pin 16 at the dlc connector

COULD BE THE REAR HEATER CORE.ITS LOCATED ON THE REAR.

remote battery?

easy fix , just remove inside door cover, and install new handle, but handle broke because of bad hendge bushings making door hard to open, driver side ususlly first to brake then passenger door a year later. need body shop to replace door bushings

sounds like the heat plate on exhaust convert

needle nose pliers

most likely OX sensor in exhaust pipe, but should be checked

hard to open door? it's probable not a handle problem, it is more like the door hindge bushings need replacing

check belt tentioner, but sound like compressor clutch