20 Most Recent 1994 GMC Jimmy - Page 2 Questions & Answers


Ok, the top line goes to transmission, as does the bottom line. They are connected at the transmission and the other end is connected at the cooler to create a path for the transmission fluid to flow through without losing fluid. One is connected at the top and one is connected at the bottom. I hope you understand this, since your question makes no sense to me.

1994 GMC Jimmy | Answered on Feb 23, 2015


hi how are you doing? just had same problem with by gmc i replaced the transfurcase motor and it works fine. the electric motor moves the shifter in your transfurcase from 4hi to 4lo and 2hi.there is only 3 things that operate your 4x4 the switch the motor and the control modgual.

1994 GMC Jimmy | Answered on Feb 04, 2015


Greetings, Some chargeing system issues are beyond simple repair. If you live in the inner city most of your Auto Part store chains offer free chargeing system analysis such as O Reillys Advance and Auto Zone. I hope this helps. Thankyou

1994 GMC Jimmy | Answered on Feb 02, 2015


You may potentially have an serious electrical drain in your car circuits. The drain is slow and continuous, draining your battery charge even if you do a start. Check the cabling and look for load on your battery with a Volt meter to check for any charge drainage. Check this as a precaution before replacing any more parts.

1994 GMC Jimmy | Answered on Feb 02, 2015


pull the starter off and with jumper cables ground the starter body and touch the big post with the positive cable and see if the gear pops out and spins if it don't replace starter and if it does work the you will have to take the transmission off to find the problem

1994 GMC Jimmy | Answered on Feb 01, 2015


Did you lube the sway bar mounting pads? If these are urethane, they will squeak like crazy without silicone lube.

1994 GMC Jimmy | Answered on Dec 18, 2014


IF IT WONT OPEN FROM THE INSIDE OR OUTSIDE THE LINKAGE TO THE LOCK HAS PROBERLY CAME OFF

1994 GMC Jimmy | Answered on Dec 08, 2014


The heater/ac control unit needs to be replaced ,

1994 GMC Jimmy | Answered on Oct 31, 2014


first check the transmission oil level with the dipstick. make sure the truck is on a level surface. there is level lines on the stick to show low and full levels. the brand of oil will not cause this but make sure the oil type is right. it should be a Dexron type oil which is for GM vehicles. if the vent tube for the transmission is plugged it can cause the oil to purge. it could be a hole in the oil pan or the pan gasket is damaged leaking the oil out or even a trans seal is bad.

1994 GMC Jimmy | Answered on Sep 04, 2014


8ef73058-f63f-49f6-8cce-e2968ffb38d2.jpg
Its on the passenger side, right across from the ac condenser.

1994 GMC Jimmy | Answered on Jul 15, 2014


hi can you turn engine over by hand [engine s not sezied ] and how did you test the battery and how did you test starter because if the engines not seized and you put a jump lead from your positive terminal off a good battery to a starters main terminal and it wont, turn over the starters faulty or there is no engine earth so connect the other jump lead from the negative battery teminal to the engine block and try again it will turn over if the starters good if the starter turns over with the jump leads check the small terminal on the starters wire is live when someone turns the ignition key if it is and the starter does not turn over then the soleniod on the starter is faulty if no live at small terminal then the ignition switch or starter relay are faulty best of luck yates2104546

1994 GMC Jimmy | Answered on Mar 23, 2014


If it is an automatic, put the shifter in the neutral position and try it. If it turns over the neutral safety switch needs adjusting or replacement. Hope this helps

1994 GMC Jimmy | Answered on Mar 14, 2014


Check to see if your AC system has been converted, take the case off of your AC fan and see if it is bend in any way, that would explain it not rotating. After you get it running you may need to replace your heating coils. I have the same problem but haven't had time to fix it. these are just my thoughts on what could be wrong.

1994 GMC Jimmy | Answered on Dec 30, 2013


Hi Nancy, this code says you have a MAP sensor fault.

1994 GMC Jimmy | Answered on Dec 29, 2013

Not finding what you are looking for?
1994 GMC Jimmy Logo

530 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 GMC Jimmy
2000 GMC Jimmy

1,327 Questions

1997 GMC Jimmy
1997 GMC Jimmy

1,100 Questions

1998 GMC Jimmy
1998 GMC Jimmy

1,105 Questions

1999 GMC Jimmy
1999 GMC Jimmy

1,080 Questions

2001 GMC Jimmy
2001 GMC Jimmy

819 Questions

Top GMC Experts

Marvin
Marvin

Level 3 Expert

85160 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Jimmy GMC

  • Jimmy GMC

Most Popular Question

spark plug gap 1994 gmc jimmy 4 3 vortec

  • Cars & Trucks
Loading...