I have lost my manual! the wrench sign lit up on my dash today. the car is kinda dragging when i push the gas. I kinda acts like it might not want to change gears. Can you tell me what the wrench sign is?
It may be that your TPS (Throttle Position Sensor) is bad or dirty. Try cleaning it, and if that doesn't work, then replace it. It goes for about $45, but if you take it to the stealership they'll run you over $200.
I had the same problem and got it fixed. Takes a couple of minutes.
Posted on Oct 15, 2008
Is it inside on passenger side or under the hood? The owner's manual didn't tell which number or size it requires. My husband isn't very mechanical. Thank you
fuse F61 20 amp (yellow) in fuse box in engine compartment
Posted on Nov 30, 2008
When it rains or I go to a car wash, I get
water in my rear quater panels of my
2006 convertible. It won't drain out.
How do I get the water to drain &
how do I prevent the water from
getting in?
This is a known issue whne the car is running down the road a vent flap will open up and road spray will get into the trunk. There is also issues with the convertable model. that isknown by ford.
Posted on Feb 28, 2009
Have a 2004 Volvo XC90. The front windows have the one touch feature for all the way up and down. Passenger window works fine and on the auto-down, the drivers one works too. However, if i operate one touch to take the driver's window up, it goes up but as it closes, it then automatically takes the window to the full open position?? Anyone have any ideas...is it switch?
Put the window down all the way and then hold the switch up, hold it until the window closes all the way up, and continue to hold it for about 10 sec. after the window is closed. Try this a few times, but if this does not work you will will probably have to take it to the dealer. They will have to do this for you with the Volvo computer scanner, this is covered under warranty if you are still with in by millage if not they will charge around 50 dollars.
Posted on Apr 07, 2010
I got codes, p0172 and p0174 (system too lean and rich). I got new spark plug and wires. I tried cleaning out the MAF sensor, but don't know if I have to replace it.
When these codes are tried together it usually means O2 sensors are going bad. I suggest you get a real scanner on it before you spend $$$$$
Posted on Jun 23, 2009
where are the radio fuses for my 2006 for mustang gt...even since the car was new the shaker 500 has had issues...the cds get jammed and the cd player says error and wont eject the cd
There could be two fuses that service the radio; one identified as 'Accessories' in the main fuse box and possibly a second in-line fuse inserted in the 12V line and under the dashboard.
Posted on Jul 03, 2010
my 2006 ford mustang heater is ;not working- it will blow hot air for about 1 min. then the air turns to cold. I need to know if there is a quick fix to this problem.
check make sure you have the correct amount of water in the resevior your heater operates off the temperature in your radiator if you car engine is cold then your car will blow cold your thermostatat opens at a certain temp to allow hot water to flow to a smaller radiator in your ac duck work thermostate is located on the top of your engine if its faulty theres your problem auto parts store will sell you a book on your car in there should be how to to many thing with your car
Posted on Dec 01, 2010
My 2006 Ford Mustang's factory alarm goes off when I try to start the engine. About 4 weeks prior to this, I had trouble starting the car on the first try (like the battery was weak). After that, no issues until I go unlock my car with the remote & turn the key in the ignition yesterday! Alarm goes off/horn blows/lights flash/radio-cd comes on. All this noise yet no engine can be started!!! What's the problem? Could it be as simple as replacing this older battery?
well im a mechanic for village auto clinic in Hempstead,Ny anyway locate your fuse box under the hood and look for the fuse for the alarm check the owners manual if not disconect the alarm start let battery charge but note dont touch radio or anything just let run for 15 to 20 min then drive to nearst mechanic so they could do further inspection to figure out why this is happning for now respond and let me now how thingsturn out...
Posted on Dec 11, 2010
Is there a separate fuse for the windshield washer pump and the wipers? My wipers work fine, but my pump doesn't appear to be running.
No they use the same fuse. The pump motors do go out. they are easy to change
Posted on Jan 04, 2012
Where is the maps sensor located on a 2006 ford mustang v6
here's two views for you
Posted on Mar 29, 2015
547 questions posted
Usually answered in minutes!
706 Questions
694 Questions
653 Questions
589 Questions
617 Questions