20 Most Recent
1984 Nissan Maxima Questions & Answers
Distributor cap firing sequence
Set the crankshaft so number one piston is about to fire and the distributor rotor arm will be pointing to the number one distributor cap segment - connect the number one spark plug lead to this.
Note the direction of distributor rotation and each lead in the firing order should be connected to each segment in that direction...
Wont star
if its getting fuel and spark. check the distributor cap and the pickup in distributor, a lot of times on the older nissans the distributor shaft gets worn out or the rotor button and the cap go bad. check for a loose dist, drive shaft also ! this is probably why it will not start, because of no spark. if dist shaft is loose you may have to replace dist, this is common on the older cars. good-day !
Describe your how to fix
you should have a working know how as to the inner workings of a steering column. the multi-switch is the most likely candidate.
Hard to start
check the vehicle for spark, fuel, and then check the airfilter as a last resort
Where is the fuell pump located
In the fuel tank. try removing the back seat cushion you will find access panel to remove it with out dropping tank.small round panel with wires.
Tranny wont shift into third gear.
you have to pull down the oil pan of the tranny. then take out the strainer inside attached to the tranny. dirt is clogging it making the sometimes shift and other not.
1984 nisasan maxima not getting
Check the Fuel Pump and Fuel Pump Relay that is in the Fuse Relay Box Under the Hood. Please Rate my Response, I need all the Help That I can Get! Thanks!
1995 3.0 engine. Where is the crankshaft (position) sensor?
In the 1995 Nissan X-Trail with a 3.0-liter engine, the crankshaft position sensor is typically located on the engine block. However, it's important to note that the 1995 X-Trail model was not available with a 3.0-liter engine. It's possible that you may be referring to a different Nissan model or engine.
To provide you with accurate information, please specify the correct Nissan model and engine.
Power locks fell into door
Remove door panel by prying out at the bottom. Follow around door and remove the panel retainering tabs. Push up on panel to remove from top of door. Now snap the window lock button assembly back in place.
How to fix 00 maxima
00 maximas don't have swirl control valves that feature wasn't added until 01 unless by some wierd chance your max was made after July in 00 and is cal spec
Not finding what you are looking for?