20 Most Recent
2005 Chevrolet Uplander - Page 4 Questions & Answers
How to reset ABS light on 2005 chevy uplander
you cannot its that simple the ABs computer is the only one that resets itself so if light on then you have a fault with a sensor on a wheel of the magnetic disk on the back of a bearing or on older the cars the toothed ring is loose .
How to program the 2005 uplander keyless remote
need to go and have dealer do it but their are some but very limited locksmiths who can flash the fob ---when the fobs were only lock/unlock you could program by pushing the lock button and turn on vehicle but with the auto door open /autostart modes the fobs need to be programmed with software from dealers
My front turn signals keep going out and when i
Please check if you have the correct part number bulbs? The front and rear bulbs are dual filiment, one for the signal and the other smaller one is a running light. If the bulb you have are correct, does your 4 way flasher function work and or left turn signal work? If the remaining rear flash ok, then your flasher unit is OK. You can also check the bulb running light by turning on the headlights. You might have a faulty or incorrect bulb if it does not light up.
I just recently had he same problem with mine. I replaced the front right turn signal bulb, but after a week of it working correctly, my wife complained that the turn signal did a double time fast flash. I found the rear bulb signal/ brake bulb was out as well. So I decided to purchase a dual pack bulb set and replace both the rear brake/signal bulbs (bulb number 4135) Your auto part store person can look up the correct number for the bulb brand you choose for the van. Since all the bulbs are about the same age and wear, I would recommend replaceing all of yours. Good luck.
How to Change brake pads and rotors
For a 05 CHevrolet. Uplander
If you are not very familiar with brake systems I suggest you leave this to the pros. Small mistakes here can result in failure to stop which could be rather dangerous. If you must do this yourself, at least buy a cheap shop manual that will give you step by step instructions and IMPORTANT torque values.
I can't get the alarm ding to stop. this is the alarm that occurs when a door might be ajar.
if the door light is also on inside the inst cluster then yes a door is ajar (even thought you may not think so) , go back and open all doors even the back one shut firmly and see if it "feels right" also look into door jam of each door and see if any projected switches are maybe damaged , switches look like small mushrooms flat top narrow shaft sometimes covered with a rubber boot . these can get caught and bent on shoes and stuff as it's being loaded and unloaded easly
Not finding what you are looking for?