1992 Chevrolet Lumina - Answered Questions & Fixed issues
1988 Ford Mustang. Turn signals won't work
If the signals come on, but don't flash, check & or replace your flasher, or swap it with hazard flasher if it's the same to confirm flasher is the problem. Hazard & blinkers are on serarate flashers.
Remove lock cylinder from trunk
Depending on the vehicle, there is probably a U shaped slide clip that holds the lock cylinder to the body of the vehicle. It simply slides onto the cylinder against the deck lid. It should have a lip on the opposite side of the U opening to grip in order to slide it off.
I have a 92 chevy
You need to have your power steering looked at. You can make sure the power steering fluid is full, first.
Car trouble,
could be a dirty fuel inject problem
run the fault code first to check for cam/crank position sensor problems or other electronic faults
and go from there
a dealer charging $80.00/ hr is cheap as where i am it is $145.00 /hr
My hood release wire is broken on my 92 chevy
If you can get under the van and using a flash light look up to the bottom side of the hood. You will see a lever hooked into a rectangular loop. take a pair of plyers and pull on the wire to open or take a piece of round metal and have someone puch down on hood and you can push the hook for the hood
I went to start my
first you half to determine if the alternater is working. you do his by jumping the car and while its running take of the neg cable off to the car if it dies then you know the alternater is not working properly,if it stays running you know you have a electricalen short you half to trace down
Change k frame on car 3.1 engine
support the engine from the topside and then remove the 6 or 8 bolts below and get a new frame. a steel bar that supports the engine will span the opening under the hood between the core support and the cowl.
How to change axleshaft drivers side 1992 chevy 4x4
It comes as a unit go to a junk yard.
6 bolts you don't have to drop the carrier take down the brake and
caliper. slide out of the hub from the inside
Inspect other parts related or you are wasteing your time
How to use slim Jim on 1992 Chevrolet. Lumina
Unless you have seen the inside of the door this is a guessing game but it can be done by feel. Place the slim jim in the middle of the window between the wiper and the glass. Put it as far down as you can and slide it around until you feel the mechanism. From there it is gently pulling, sliding and caressing it until it pops. If you can see the manual lock on the inside then you can watch for the to jiggle and you know you are in the right spot.
Not finding what you are looking for?