1991 Chevrolet C1500 - Page 3 - Answered Questions & Fixed issues

Go to Autozone, There you can get downloads, for pretty much everything.

should be screwed into the waterneck.

they should have told you what to fix when you failed the test. Far too much to start guessing....

easier to just replace it. Not too hard on those.

Do you know how much it would cost me to fix my <a href="http://www.nationaltransmission.ca/manual_transmission.htm">manual transmission in Calgary</a>?

ever find the problem?im havin same thing

I assume you have a 5.0 or 5.8 throttle body injected GM engine? It's as simple as removing all the torn screws on the top of the throttle body. Replace the parts needed, and reinstall in reverse order. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

I would suggest checking the alternator...could be DRAINING THE POWER THATS WHY NO CLICKING

You'll probably need to either replace the cluster with a used one, or send your cluster out to be fixed. Most dealers offer an exchange service for a fee. You get a rebuilt unit with the mileage set to your current number.

T.C.M. MODULE & WIRING HARNESS. GMC. $ 147.49 Chevrolet C1500 2WD PICKUP, 1991, 1992, 1993. Chevrolet ,you can see clearly what you need!Watch out because not necessarily is the TCM,If you put more details may be we are able to help you out!

What happens if you unplug the O2 sensor? I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

.040"Should also say on the emissions sticker under the hood. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

The speed sensor in the transmission may not work without the computer being connected in the circuit.

Replace the rubber brake hosesThey are collapsed insideYou never do only one caliper,you do bothNow you need to turn the rotors & new padsTheir fried

http://www.youtube.com/watch?feature=player_detailpage&v=DqGNc7gE3uo

What is the fuel pressure at idle ?And do you know which cylinders are getting too much fuel ?

Could be your turn signal switch!
The brake lights in this run through the turn signal switches!

The handle is hooked up to two rods, one going to each side of the tailgate. If you remove the bezel around the handle, you should be able to reach them with a screw driver or some pliers.

Now clean MAF , install new TPS , Clean injectors .

Really, mine didn't, it works fine.....LOLOL No seriously how about some information.