20 Most Recent 1999 Nissan Sentra - Page 3 Questions & Answers

how to set the timing chain on the ford 1.6 rocam engine

how to timing chain on 1.6 ford ocam engine

I had the same problem. What you need to do is under the driver's side rear is a black gas canister unit that is supposed to filter gas in the neck. There is a check valve that you need to remove and replace or you can use WD-40 to unstick it. That valve is in the closed position so when you try to fill up the tank, the tank gets pressurized. I cleaned mine and it needs it again. The valve is around $60. I think, but could be wrong. Hope this helps,,,

check battery,is it fully charged,battery terminals.sand the b/post ,, also check is the b/light comes on on the i/cluster,recharge battery

there is normally a spacer on the bolt that positions the pulley the correct distance to miss the mounting bracket. IT sits between the bracket and the inner race of the bearing and locks that race so that the bearing can operate correctly.

MAS Mass Air Flow Sensor is not working, or the cat-converter is plugged.

There are 2 speed sensors on the transaxle. One is for vehicle speed and one is for trans output shaft speed. My guess is that you replaced the one for output shaft speed.

Nissan Scope Technician- 10 years with Nissan