2000 Mercedes-Benz E-Class - Page 2 - Answered Questions & Fixed issues
Ma benz e 240 is not changing from gear one
i take it is an automatic chech the gear box oil level if there is not enough oil in the box it will not change open the bonnet ther should be a filler some where on the ( if you looking at the engine ) left hand side near the bulk head of the engine bay a red ring similer to the dip stick make sure that it is the filler for the gear box check level first then top up
2/13/2014 9:50:39 AM •
2000...
•
Answered
on Feb 13, 2014
•
110 views
Steering wheel stuck
Forgot to mention I am sure that you can not turn your key.
I am also certain that you are not able to start your car.
If there is any red light blinking one would simply need to turn the key on and press the disarm button at or near the blinking light not hard to find.
The best shot is that there may be a force preventing the key from turning, this would usually be a force against the steering wheel. If you are not able to remedy the situation as I described to you on my previous answer try this. Have some one help you to jack up the front wheels just clear of any roadway or parking curb then try to insert the key release the wheel apply the brake select netural and then let the car back onto the roadway.
2/2/2014 8:57:32 AM •
2000...
•
Answered
on Feb 02, 2014
•
94 views
Codes free online
you need to show vin and proof of ownership to get radio code
11/12/2013 2:39:51 PM •
2000...
•
Answered
on Nov 12, 2013
•
50 views
Noise when applying brakes on my e240
Brakes could be worn down allowing a safety feature to make a noise, or if it is a grinding noise your disc pads are worn out and need replacing
11/1/2013 8:27:19 PM •
2000...
•
Answered
on Nov 01, 2013
•
113 views
2001 e320 cdi estate changed battery turned on and
You may just need to reset your throttle sensor. There is no hard connection between the gas pedal and the engine its electronic. To reset :All auxiliary systems must be off (radio, lights.aircon, etc) no
electrical drains or CAN signals can be triggered during the process.
Turn the Key to the "on" position (the position right before you start your engine)
Press and hold your gas pedal down for 5-10 seconds
Turn Key to "off" position (dont remove the key) and then release the gas pedal. than wait 2 minutes, for the system to reset. Again without touching anything or having anything on.Thats should do it. When you replace the battery you usually have to do the radio code, yaw steering sensor, throttle and sometimes transmission. On my last battery just had to do the radio but was expecting to do all.
10/2/2013 11:16:20 PM •
2000...
•
Answered
on Oct 02, 2013
•
200 views
How to remove clutch master cilinder from Mercedes
jack up car the cylinder sould be on the drivers side right hand drive its on the gear box there will be a pipe which feed the cylinder remove this you will loose fluid from this pipe try to stem the flow by wraping cloth around it or let the pipe run dry as you will have to bleed it again any way there will be two bolts holding the cylinder on remove these take off the old and just repeat the steps above to replace its any easy job then just bleed the system the same way as you would bleed your brakes there is a bleed nipple on the cylinder use this to bleed the system with thanks ivan
8/24/2013 5:24:47 PM •
2000...
•
Answered
on Aug 24, 2013
•
145 views
MERCEDES E240 2003 MODEL MALFUNCTION ELECTRICAL
hello i have a mercedes-benz e240 class model 2003, i have a big problem... ihave a allarm light whith this Specifications: Malfunction, Electrical Consumers switched Off. whould you please help me. thank you
2/22/2013 5:56:06 PM •
2000...
•
Answered
on Feb 22, 2013
•
1,408 views
Low engine temperature
you can try removing the thermostat and check to see if it needs to be replaced (if its worn).
also, you can check the temperature cooling sensor. (this sensor sends temperature information to your cars computer). good-day !
12/8/2011 7:43:16 PM •
2000...
•
Answered
on Dec 08, 2011
•
81 views
Not finding what you are looking for?