2000 Mercedes-Benz C-Class - Answered Questions & Fixed issues
How to replace the fuel tank filler pipe mercedes c200 kompressor
You can check to see if the hose clamps are tight on the filler neck and the breather hose ,i would also check the fuel filter under the car rear near tank for leak's as this can give the smell of fuel around the rear of the car . when you open the boot of the car do you smell fuel or is it only on the outside of your car????? hose clamps and fuel filter = outside of car. smell in side of trunk (boot ) fuel return line hose clamp might just need to be tightened up. you might have to remove the rear wheel and inner wheel cover to get to the Fuel tank filler to check the hose clamps.
2/12/2018 12:24:45 PM •
2000...
•
Answered
on Feb 12, 2018
•
235 views
Unable to add gas
no
it means that the EVAP system has a problem with the purge valve / vent solenoid and that is an easy fix
12/20/2017 10:20:46 AM •
2000...
•
Answered
on Dec 20, 2017
•
48 views
How do i adjust my wipers to park correctly on my 2000 mercedes c230 kompressor.
If the linkage is ok and not the cause of the mis-seating, there is a cover / cap type bit that covers the very end of the wiper arm, where it bolts to the linkage.
Remove this cap / cover and there will be a nut of something like 10, 12, 13mm. Loosen this (or take off) and then you can move the wiper arm on the splined stud until it sits correctly.
Ensure you bolt it back up to a similar torque and that you test for operation and the field of view it clears, before you drive. It also takes a minimal amount of movement of the arm on the stud, I tiny spline makes lots of difference at the blade end, so be gentle and ensure splines are seated correctly.
6/5/2015 10:40:18 AM •
2000...
•
Answered
on Jun 05, 2015
•
114 views
Relay location
In your bottom were the cancer is
7/25/2014 7:56:11 AM •
2000...
•
Answered
on Jul 25, 2014
•
57 views
Fixyablog post17762
You need to get it connected to merc star computor to narrow the problem down it could be many things you wont get a difinitive answer here
5/6/2014 10:00:50 PM •
2000...
•
Answered
on May 06, 2014
•
70 views
Mercedes benz limp mode
You need to first have the systems computer scanned for fault codes.
4/2/2014 11:17:02 PM •
2000...
•
Answered
on Apr 02, 2014
•
712 views
How to clear check engine light
engine lights normally have to be cleared by resetting the CPU. use a scanner for this purpose.
4/2/2014 10:13:06 AM •
2000...
•
Answered
on Apr 02, 2014
•
214 views
Not finding what you are looking for?