Top 20
1997 Mercedes-Benz E-Class Questions & Answers
Hi there, I have got
since the windows is open then try unloking it from the inside
9/7/2017 3:39:03 PM •
1997...
•
150 views • 0 helpful votes
Code p 1747 p1605 p600
code p1747 refers to CAN data bus, TCM /instrument panel--malfunction===causes wiring---connections--trouble code/s stored in other system/s
I don;t have the other codes but code p 1603 refers to the same CAN bus fault
call a service dealer to get the p 600 code explanation
10/26/2015 8:21:09 PM •
1997...
•
791 views • 1 helpful votes
1997 mercedes benz e320 ets light is on and car keep cutting off
ETS is your electronic traction control system... that would not make the car cut off. Check battery voltage, alternator output voltage (autozone can do this for you) and fuel pressure (cutting off may be a bad fuel pump / filter )
3/27/2015 11:45:18 PM •
1997...
•
986 views • 0 helpful votes
Mercedes e230 97 gear knocking on 1st and 3rd gear
sounds like an internal gearbox issue so other than changing the transmission oil there is little else i could advise so it will need to be inspected by a mechanic , sorry no easy fix that i can think of
4/3/2015 7:42:11 AM •
1997...
•
135 views • 0 helpful votes
How do i put transmission fluid myself in a 1997 mercedes benz
Transmission fluid (ATF), like engine oil, should be checked regularly. The transmission box has a dipstick, like the engine. To check the ATF level, firstly locate the dipstick which is in the engine compartment. You will see the tube which carries the dipstick runs at an angle to the transmission box as opposed to the engine oil dipstick which runs almost directly down.
Checking the level involves starting the car and while the engine is running with the selector lever in P (Park) remove the dipstick, wipe it clean, then push it back and remove it again. Now you can check the level. Fluid is usually added into the dipstick tube.
If you are losing ATF, check for leaks because the A/T usually does not consume ATF.
11/3/2014 3:03:52 PM •
1997...
•
378 views • 0 helpful votes
1997 mercedes wont go in drive until i have driven in 3rd gear
BUMMER DEAL! It could have a sludge problem that needs that lower gear nudge to get it to shift. Just changing fluid is not enough. You need stronger medicine. Try this Mega Power product as it seems made to end that problem. Hope this helps.
11/3/2014 2:59:31 PM •
1997...
•
94 views • 0 helpful votes
How do you know when transmission fluid is low in mercedes
All the Mercedes I have serviced over the years require a "special tool" to check the fluid level. It is a dipstick, just like for engine oil and has markings on it for "full" at various fluid temperatures. I'm not sure where you could get one. I have been fortunate in being able to borrow one from a dealership where I know the service manager.
11/3/2014 3:07:24 PM •
1997...
•
91 views • 0 helpful votes
1983 Mercedes-Benz 280SE
Its a green relay with a fuse, should be in one of the two compartments behind the firewall
5/12/2014 4:22:04 PM •
1997...
•
217 views • 0 helpful votes
Not finding what you are looking for?