20 Most Recent
2006 Mercedes-Benz ClLK-Class Questions & Answers
How do i replace a MAS in my 2006 clk 500?
pull off the engine air cleaner housing and at the back of the engine you will see the mass air flow sensor. there will be a clip at the back on the bottom that you have to press backwards on to release airmass sensor. remove airmass and install new one. then have the adaptations reset. this is also a good time to replace engine air filters because usually after replacing air filters the airmass goes bad soon after.
10/9/2010 7:17:13 AM •
2006...
•
Answered
on Oct 09, 2010
Broken fan belt needs replacing
go to mercedes benz website and download your owners manual it's in there - or look at the one you have
mbwebsite - owner support - download manuals
10/29/2009 7:47:10 PM •
2006...
•
Answered
on Oct 29, 2009
Where is my fuel filter
On all fuel injected vehicles I have ever seen it is located on top and inside the fuel tank. Yours should be in the same place.
9/22/2009 4:46:39 AM •
2006...
•
Answered
on Sep 22, 2009
How dependable is the Mercedes 722.6 transmission?
most Mercedes cars mechanics are pretty bullet proof but as in all cars you do get bad ones no car is totally reliable the only problem Mercedes had was the rust problem which they have now solved but now as all cars they have filled them up with electronic gismos so there is something else to go wrong
Why won't my 2002 Clk 430 crank and shift into drive? It was in a minor accident.
depending on the amount/location of damage to the vehicle you could have damaged the wiring harness leading to blown fuses, or damaged important sensors/relays that, if damaged, wont allow the vehicle to start. or you could have tripped the rollover switch which cuts the power to the engine in the event of a rollover to help prevent fires. but can be set off if damaged or hit hard enough. Start checking fuses and wiring on the damaged part of the vehicle. I hope this info helps.
I left top half way
first try with disconnect battery ground cable, disconnect cable an leave 2 minute then fix it back and have a look, if not work now it's position uneven, you must close the roof slowly by hand up to locking position after that first operate the switch for closing and let it lock properly then till lock the boot lid to the right position with two flaps then switch off ignition let it stay 5 minute without doing any thing and, after that open the roof, if not work in this way you must fix Mercedes diagnose tool in to the car for manual activation through diagnose tool, and also would like to ask you to check the boot separation flap again is it in the right position if it not close properly it won't work,
Not finding what you are looking for?