Top 20 1998 Chevrolet Corvette - Page 8 Questions & Answers

At very cheap rates you can go for manuals from this store. Just check Chevrolet Corvette

Some of these old wiper systems had ground issues. Try to run a ground wire to the unit and then a ground point were the wiper motor is mounted. The original would have had a ribbon ground strap that would have provided adequate ground in most cases, but in some cases, just running another ground was needed to fix this problem.

I would recommend a gasket seal be fitted with silicone at bothends at the cylinder heads ( maybe check your PCV Valve also ! )

isn't there just a connector under the seat so you can just leave the switch in the seat and disconnect the connector below ?

clutch disc is in backwards more than likely.

replace unit.

Maybe pressure regulator

Body & Frame Hardware Parts (corvettemods.com)

Under the dash on the drivers side.

Could be faulty relay or bcm

Check fuel pressure. Pump may have crapped out. If pressure is good, clean and rebuild carb.

If you are having starting issues, it's probably the security system acting up. Happens a lot on those vehicles. http://www.vatspasslockpasskeysecurityhelp.com/

Usually the gear in the transmission outpu housing is plastic. It likely has failed/

Have a picture ?

If you have ABS then a special tool is required to bled the brakes.

Did you do tune up, fuel filter? could be the crankshaft sensor.What is battery crank power? Air filter.

Hello Joe, Please follow the link for some details. https://www.corvetteforum.com/forums/c3-tech-performance/873152-power-steering-slave-cylinder-rebuild.html

vats system has to be reset

Testing the turn signal electrical circuit is the way to the fix > Videos on youtube , automotive electrical testing . Find a wiring diagram at Basic Electricity for Service Techs Ohm law Current Flow Opens Shorts also how to use an read wiring diagrams .

You have a defective fader control.