20 Most Recent 1994 Oldsmobile 88 Questions & Answers

Fuses (located on a swing down unit near the steering column or in the glove box) protect all the major electrical systems in the car. In case of an electrical overload, the fuse melts, breaking the circuit and stopping the flow of electricity.

I suggest check your 1994-Oldsmobile-Eighty-Eight-Owners-Manual for descriptions (page 223 and next).

Hope this help..

its on the firewall on the passenger side it has a green elec. connector ....

Did you make sure that new O-rings were installed?

You will need to have engine codes pulled from vehicles computer and perform repair, before the light will go off.
Any diagnostic repair shop should be sufficient to help you. A place that specializes in engine diagnostics and engine repair. If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_62314e5b2470e8b5

Its the harmonic balancer. The rubber in the balancer has disintegrated and not balancing the motor any longer. You have to install a new one.

Use an ohm meter to verify the switch is or is not operating correctly.

Here's a Autozone repair guide on your belt. Repair Guides Routine Maintenance And Tune up Belts AutoZone com Here's another link to your belt diagram. 1994 Oldsmobile Eighty Eight Serpentine Belt Routing and Timing Belt...

Had same problem on a 1995 buick , problem was crankshaft position sensor

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem. Best Manuals

Note the picture. I consider the transaxle mounts part of it.

Intake manifold-to-cylinder head bolts....96 in-lbs Intake manifold, upper to lower bolts ....132 in-lbs Tighten all bolts from center of manifold towards the ends.

This may be related to the antitheft system The system is known for turning off the starter and/or injectors when it fails. Is there a light on the dash that says SECURITY? This is a common problem worth looking into especially after a motor has been changed. The bypass they did may be failing. http://www.diy-gm-security.com/

at an oldsmobile dealer

Some cars..the module is affectd if batt ran low..below 12.6v they can be ruind. Test batt for holdn a charge. Same w alternator. Also the main cable from batt to alt cud b worn causing low flow

sounds like the neutral safety switch needs to be adjusted, and/ or there are some loose fasteners at the linkage to/from the shifter

It is in the A/C line leading into the evaporator. There will be a pipe-to-pipe connection right before it, and the pipe reduces in diameter right after it. You will need a special tool to remove it. You might try needle nose pliers, but be careful if it's never been replaced before. It could come apart.

alternator ! batteries have about 30 minute reserve if you have the patience to wait on the side of the road to recharge itself, but it will only do this about two times, so get to a service station as quick as possible because your running on battery power alone.

For the brakes take it to an accredited brake shop and for the steering take it to an accredited steering and suspension shop. If they are not accredited then there is every chance that you will get ripped off.

Sounds like the motor and gearing has worn out, they take a lot of punishment. Replacements are available (sometimes it works out much much cheaper to buy a whole second-hand seat). But that depends how much you like the car...