1992 Oldsmobile 88 - Page 8 - Answered Questions & Fixed issues

You have a bad ABS unit most likely. It could be a mastercylinder, but with the light on I would go with ABS unit. Sometimes unplugging it and leaving it unplugged will help. I have seen this work 3 out of 5 times.

The bolt is right hand thread. I do believe it is adjustable. But you can readjust it if needed after the balance is installed from the bottom.

i am sorry i do not know but i hope this help you try the websites www.autozone.com and www.alldatadiy.com and if all fails stop by your local library and get your hands on a Haynes auto repair Manual for your car.

sounds like a plugged fuel filter.

The crank sensor is behind the harmonic balancer. Not too hard to replace, the harmonic balancer is supposed to come right off but I needed a big 2-jaw puller to get it off.... accessed through the wheel well.

The sensor itself cost about 130 bucks and the sensor is located on top of the motor. It shouldnt take that long to fix it has only 3 screws

you need to check the fuselink to make sure they are clean and the ground is good and the plug behind the dash also give these guys a try it Schram auto & truck parts they sells only GM-parts 1-800-292-1032 and they website is www.schramauto.com and i hope i have been some help to you.Michigan Man

have the starter checked and also does the dashboard lights dim when trying to start

check your crankshaft position sensor it may be gone bad

take key to dealer and check resistance. if key is OK probably wire is broken in column from ignition or ign switch is bad

you need a new blower motor
I had same problem

Take the battery cables off and hold them together for 3-5 minutes, this will reset the computer and the car should return to normal.

i have an injector test done

I think you should check your connections on the back of the altenator, something is wired incorrectly, if necessary hook up one wire at a time and see what you get. There should be only one large red wire on the BATT connection, and the rest should be in a molded clip that plugs into the altenator, check and ensure that they have a good connection when you hook them up.

The O rings on the fuel injection system can be tricky to install. the problem is usually during reinstallation the O rings get pinched. It is possible to replace them yourself. but I would take it to a shop if I had to replace them. the MAF sensor being crushed is not good either.

Sounds like it is telling you that the Airbag is Faulty.

what pulley? water pump most likely. Could be alternator. More info needed. Apply spray penetrant/lubricant like WD-40.

can de it's more time comsuming then anything but takes a bit of research to replace proprely

if the display doesn't light up it is probibally bad check the fuse first then check if u got power at the blower motor.

its either the low pressure switch or the relay for the a\c