20 Most Recent
1988 Oldsmobile Cutlass Ciera - Page 3 Questions & Answers
How to change out anything
Make sure whatever (I mean even the easiest most simple part/sensor etc.) is taken out, is also put in EXACTLY the same way. Take a picture or something because its hard to find manuel or diagrams for this specific car and these have problems all the time it seems. Ex) TPS needed to be changed and when it was changed the "arm" was put in on the wrong side of the "pin" (not easily noticed unless you know that had be messed with and looking directly at it) car idle was extremely high and was easy fix but stupid long time issue.
What would be wrong with your 88 olds cutlas ciera if you're driving down the road and car dies and won't restart?
My car did this for a while until it would no longer move and I was told all sorts of things including cleaning (all the gunk near the MAF -hosing) which made it run for a month but did idle too high. So diagnose and get the codes from your car- the paperclip way (autozone cant cause its older than 1992).Codes I pulled pertaining to this issue were 22 (Throttle Position Sensor- TPS Signal Voltage Low) , 23 (Air Intake Temperature- MAT Low Temp Indicated), and 34 (Mass Air Flow Sensor- MAF)Easy to DIY with these 3 sensors
Antifreeze leak
Sounds like it might be a leaking water pump behind the pulley.
Broken exhaust pipe
measure the with tape line and go to autozone and they will give you whay you need. Alot of times if a middle section of pipe is missing flex pipe is your best option and easyest to install. Better than that even would be to take it to muffler shop and have new pipe welded in..best of luck
Not finding what you are looking for?