20 Most Recent
2002 Mercedes-Benz S-Class - Page 3 Questions & Answers
Defective turn light sensors on 2002 Mercedes S430
Are you sure ALL lights are working? If one or both rear signals are out, the system is capable of powering a different bulb (such as a brake light or marker light). There aren't really "sensors" that detect a bulb outage. Each bulb is power separately by the Signal Acquisition Module, which sends power through the bulb, and then to ground. If a bulb is burnt, there will be no current flowing to ground. This is how it detects a bulb outage. Your best bet would be to take the bulbs out and inspect all of them.Hope this helps!
2/11/2013 12:16:19 AM •
2002...
•
Answered
on Feb 11, 2013
How do i raise up & down my back sun screen in my s430
There is a button on the console dash area. I believe it has an arrow or lines like if you were composing an email (indent or outdent). It should go up and down smoothly without getting jammed or wrinkled up. I have some kind of kink in mine and have to have assistance when putting it up and down. So in Texas it just stays up. Happy Benzin.
1/29/2013 7:41:15 AM •
2002...
•
Answered
on Jan 29, 2013
FUSE DIAGRAM S600 2002 S600 MERCEDES
i HAVE PROBLEM WITH DOOR LOCK COULD IT BE THE PUMP.LOCKS .WHEN I PRESS THE REMOTE KEY THE LIGHTS ON MIRROR FLASH INDICATING THAT THE REMOTE IS WORKING. COULD IT BE A FUSE IS SO WHERE IS FUSE LOCATED OR IS IT DOOR PUMP AND WHERE IS THAT LOCATED
12/10/2012 4:41:50 PM •
2002...
•
Answered
on Dec 10, 2012
There is no power on the AC compressor and the Ac
If the system is low on charge then the compressor will not engage. The first thing you need done is to have the pressures checked in the system, if they are low find the leak and repair it before recharging the system.
10/2/2012 9:09:19 PM •
2002...
•
Answered
on Oct 02, 2012
Where is the steerin column ground in a mercedes w 203
In the mb w 203, steering angle sensor (sas) is plugged in the multifunction module which is connected to the wiring harness through a snap on connector. The scan tool was constantantly indicating the fault in the sas where as on diassembly I found that one of the connector pin in the module was broken. I changed the module and the problem was fixed.
Hamid Javaid.
8/31/2012 9:21:03 AM •
2002...
•
Answered
on Aug 31, 2012
Not finding what you are looking for?