20 Most Recent 1992 Oldsmobile Cutlass Ciera - Page 4 Questions & Answers

Here's a link to replacing your back brake shoes.

You have got to space it by feel,so it does not touch either side of the reluctor plates,check the balancer reluctor plates to make sure they are not bent,and the balancer is not coming apart in the rubber part.

No & you may not have proper controlover the fuel injectionYour living back in the 1950'sThe motor will run too cool for the computerto do it's job.Engine coolant has to be at 205 to 210 allyear round & you have to have a thermostatfor that to happen.

Chances are you lost vac to the control or the blend door under the dash. Most models built before 1999 used engine vac to move the blend doors. You may need a shop manual to get the diagrams to trace the vac lines.

What nut do you refer to?

2 digit trouble codes 15coolant sensor or circuit/low temperature indicated 16system voltage out of range 21thottle position sensor[tps] or circuit vottage high 26quaddriver module circuit43low voltage at ecm terminal l [carbureted models]

Not really.The computer controls idle speed by using the idle air control valve depending on the load on the engine among other things.

4 cyl or V6 engine ?

Yes. You always need a puller for the harmonic balancer. Never try to remove it without a puller. You may be able to rent one at the auto parts store or borrow one from a friend. Hope this helps.

Code 45 is for a rich O2 sensor. If you have already changed the sensor, the fuel mixture may actually be rich.Possible causes include a leaking fuel injector, faulty fuel pressure regulator, or other problems.

in the fuse panel and usely there is a code like number thing in it and it has numbers with the word sighal flash..somtimes to these fuses is under the hood of these cars in a fuse panel..

Your Window Regulator is work, and needs to be GREASED... Your Motor is over heating.When did they quit? did they all stop at teh same time?

Try and clean the entire motor and antenna setup.

This is 3.8 engine,replace valve covers gasket.I have mine in hands now.I have to do mine.

It is on the end of the top radiator hose w/2 screws holding it to the engine BUT you must first remove the throttle body above it so you can access it. I did the job it took about 1 hour total

at an auto wrecker

If you have the 4 cyl engine, the oil filter is in the oil pan.