20 Most Recent
2002 Dodge Neon - Page 4 Questions & Answers
Blinking Check Engine light
This is typically a sign of a "detrimental misfire". A blinking check engine light means DON'T DRIVE ME! You may want to have your coil pack checked, plugs replaced or gapped properly, or wires replaced. Would also have to do with the camshaft sensor causing your timing to be off.
2002 dodge neon, no power to the obd?
If your saying pin 16 at the data link connector has no voltage, check the fuse in the diagram. Not only check the fuse, check the fuse circuit for voltage
Wont start or turn over just replaced the stater and still nothing
Does your key switch work good? Do the warning lights and gauges on the dash all turn on with key in on? That verifies the ignition switch has power. If not, check fuse #9 in the Power Distribution Center (under the hood). It is a 30 amp fuse, providing power to the switch.
Are the battery cables clean and tightly connected at the battery and starter and the battery ground connection?
There is an Engine Starter Motor relay in the Power Distribution Center, the only thing between the ignition switch and the starter. With key in start, power is sent from the switch to this relay, and if relay is activated by the PCM (engine computer), then power goes on to the starter solenoid on the starter, and starter should then operate and crank the engine. If you have a voltmeter, you could do some tests for power at the terminals the relay plugs into. There are only 4 terminals. Post back with comments, or if you need help with testing those terminals.
My 2002 dodge neon wont shift out of first gear
You need a transmission shift solenoid. Copy and paste this linkhttp://www.amazon.com/Dorman-698-100-Transmission-Shift-Solenoid/dp/B000IY78Q2/ref=au_pf_pfg_s?ie=UTF8&Make=Dodge'40&Model=Neon'312&Year=2002'2002&carId=003&n=15684181&newCar=1&s=automotive&vehicleType=automotive
Front end collision repairs, inquiring about tools needed todo so
If you have never done this type of work before you should have the junk yard pull them for you. The core support Are you speaking of the Radiator core support or the strut support tower Both of these items requires a cutting tool and or spot welder drill bits to remove for instance the radiator core support will need to be drilled out and many pieces removed are requires the ability to take pictures and know where everything goes back not to mention some extra tools the average for it your self won't have. When doing core support or using a cutting tool the Junk yard won't allow you to remove it yourself do to liability.
Not finding what you are looking for?