20 Most Recent 1998 Dodge Dakota - Page 7 Questions & Answers

Turn signal switch is shorting out very common to go out as it is a wear and tear item over the years.

Easy take out the two screws in the arm rest then if you have one a door panel remover tool if you dont have one then use a screw driver are a pair of needle nose pliers to separate the panel from the door. The reason I said to use pliers is that there are plastic tab holders behind the panel find them pry each one out there should be around eight are nine of them after you get the panel lose pull up and back while making sure the inside door handle goes through the panel opening. Install in reverse order. Good luck it realy is that simple .

Size 24 or 27. I found this on the AutoZone website. You can too.
Good luck!

bad gas go super unleaded

U must put it on the points should have arrows

the signal light flasher & hazard flasher are located where your fuses are.

Follow the flasher wiring to fuse box and locate the fusible link. Looks just like the wire but softer exterior and it's a fuse able wire that can break down. Should be along the driver fender under hood.

have the fuel pressure and volume checked with a gage. if the pump is going bad it may not start at times. you don`t say why your asking. when the pump goes it will show some kind of symptom.

This can be welded or if its rusted then cut it out and weld in a new piece. If this is just one of the peice that go across the bottom of the bed for support then dont worry about it, the bed will be okay, unless you always carry alot of weight in the bed then to avoid the floor of the bed to bend some then repair it.

Just a systems check. If it stays on after the truck starts, take it to the dealer or a repair shop. You know, you could always read the owner\'s manual.

Timing isn't responsible for carbon fouling. Carbon fouling is from too much oil leaking past the rings - worn engine.

What about it? Never saw any vehicle the switch wasn't located behind the brake pedal arm How would it turn on when you stepped on the brakes

Try the brake Pedal where it pivots under dash,should be a switch with two wires or on the brake master cylinder or near by in the brake line.

Sounds like either the Mass Air Flow Sensor could be dirty or defective OR a simple vacuum leak. To check for a vacuum leak, get a can or injector cleaner or even WD40, and spray around the intake until you hear a change. To clean the MAF sensor, BE SURE to get sensor cleaner NOT carb. cleaner!! Or, you can take it to Auto Zone and have the "Codes" checked FREE. Hope that helps. :-)

you may have a plugged fuel filter as you don`t say if you have changed it. also have your fuel pressure tested with a gage, it should run about 36 lbs pressure if its multi-point fuel injection or run at about 15/18 lbs pressure if its a throttle body.

Pads up front (Caliper) Shoes in back (Drums). Any parts store can get them for you.