1991 Mitsubishi Eclipse - Answered Questions & Fixed issues
I have a 1991 eclipse gs 1.8 and recently bought a
If it has it it needs it.if there is no port for it in the new cai you need to send it back and get one that has a port for it. Or drill it out and put a rubber gtomet in that will fit your mass air flow.
Not geting oil in head
If you have had the head off check that the head gasket has an oil hole to allow the oil to get to the head
Is there a fuse connected to alternator that can
there is no fuse on an alternator, but if the charge light bulb on the dashboard does not light up when the key is turned on to ign and go out when the engine is started, then the alternator primary coils will not get power and the alternator will not work. changing the bulb will normally cure this particular problem.
if the light does come on and go out as described, then the problem is an internal fault in the alternator
How to change transmission fluid
You will most likely have to remove the transmission pan itself to get the fluid out. Very delicate work but take all the bolts out except the 4 corners. Slowly take 1 side of the 4 corner bolts out. then slowly take the other 2 bolts out from the other side. Loosen those last 2 bolts a little at a time changing from 1 to the other. It will be like you are trying to "Pour" the fluid into the drain pan. Depending on the mileage on the car you might as well change the filter as long as you have the pan off. When you buy the filter kit, most of the time it comes with the gasket as well. Messy job if your not careful. Good luck
Over heating
- Auto inspections of the vehicle may produce results contributing towards restoration. For example, the auto technician makes the evaluation as separate arrangement from which problematic areas are ascertainable. The result findings are documented as diagnostic draft plans from which repair authorizations are achievable. At which point, diagnostic without repair requirements would least requires any further procedures. However, once the vehicles diagnostics produce result requiring expert vehicle repairs, the next sequence of procedures are initiated. First, vehicle repairs require constituent components either permanent parts or depleteable resources constituents prior to workshop initiation plans. Auto technician diagnostic plans would usually contain the damage of the vehicle. A decision to commence restoration of the faults would produce estimate drafts in parts repaired for either replacement acquirable, leasable or alternately. The next sequence includes calculations estimates in resources that would be required contributing towards entire workshop restoration process procedures.
Lack of power, i just
check the fuel filter for not letting much fuel through to engine. if this helps a bit. make sure air filter is clean. and the maf sensor may be dirty or contaminated. the maf can be cleaned, just go to any auto parts store and buy a can of maf sensor spray to clean it. remove from car to clean. be very careful not to touch in side of maf sensor with the spray straw or any thing else. just spray to clean it. let dry and put back on car. just follow directions on can.you can also use electrcal cleaner, if need be. have a good day !! ( manifold air flow )
Where is the starter on a 1991 eclispse 2l awd
Hope this helps, it it does please leave feedback and vote Thank You and Good Luck
Removal
- Disconnect battery cables, then remove battery and battery tray.
- Disconnect speedometer cable from transaxle.
- On models equipped with 1.8L/4-107 engines, remove intake manifold stay.
- On all models, disconnect starter wiring connections.
- Remove starter mounting bolts, then the starter.
Installation
- Before mounting starter, clean the mating surfaces of starter and the engine.
- Install starter and torque mounting bolts to 20-25 ft. lbs.
- Connect starter wiring connections.
- On models equipped with 1.8L/4-107 engines, install intake manifold stay.
- On all models, connect speedometer cable.
- Install battery tray and torque attaching bolts to 6-10 ft. lbs.
- Install battery and battery hold-down. Torque hold-down bolts to 1.5-2.0 ft. lbs.
- Connect battery cables.
My 1991 mitsubishi eclipse does not have spark the
The other two coils you tried were they new or used and how do the wires connect to the top of the coil do they bolt on or is it a snap on cap? If it is a snap on type replace it with a new one. It may not be making propper contact with the connectors in side the cap. There should be at least 12 Volts going to the coil. Also replace the high tention wire from coil to distributer cap. Good Luck and have a good XMASS.
1991 mitsubishi eclipse gs 1.8
If it is the starter clicking try tapping it a few times see if that dont free it up.Sometimes they just get hung up. sometimes if you battery is not putting out good it will also just click because it does not have enough power to turn it. If that dont work you can tell me what happens and i may be able to help you further.
Not finding what you are looking for?