20 Most Recent 2006 Chevrolet Malibu - Page 4 Questions & Answers

ABS brain

A vibration when the brakes are applied can indicate that the brake rotors have warped and either need to be machined until true or replaced if they cannot be machined.

this indicated you have warped rotors and or warped brake drums if it has rear drum brakes. also the quality of brake rotors is poor and the metal flakes off the rotors causing this problem to happen as well.

Throttle Actuator Control Motor

There are a few possibilities...

1. Starter improperly shimmed and is biding to flywheel.
2. Starter or flywheel teeth worn causing binding (not likely)
3. Starter solenoid return spring broken.
4. Ignition switch problem causing starter to stay powered after key released.

Were will the reset button is

Info should be in your owners manual. The fuse is usually placed in the fuse box in the engine compartment.

I don't believe I've ever heard the Song of the Steering. Please hum a few bars and maybe I will recognize it. Did you have a question?

When you turn the wheel to the right, the vehicle (when in motion) will veer to the right. Conversely, when you turn the wheel to the left, the vehicle (again, when in motion) will veer to the left. The turning of the steering wheel is made easier by the advent of the electric power steering. its precursor, hydraulic steering assist, performed the same task in a different manner. Is that what you were asking? NO? SHOCKING! (PLEASE ASK AN ACTUAL QUESTION THAT CAN BE ANSWERED.)

The brake sensor switch most likely needs to be calibrated at a Chevrolet dealer. Call one and ask them about it.

Sounds like you are developing a coolant leak into your oil. Some of these engines have been known to blow an intake manifold gasket and leak anti-freeze into the crankcase. Most times, it is a head gasket that is blown out. Good luck.

don't understand question

lower the gas tank, remove the gas pump mod. There will be a sending unit on it . sometimes you can get the sending unit separate,sometimes the whole unit has to be changed.

three places under driver side under dash or under hood or in glove box

This is a code for the Evap systen. Could be as simple as trhe gas cap loose or missing. Always look for the simplest things first. could be a broken or loose or dissconnected hose in the evap system anywhere between the gas tank and the evap can. . The evap system removes the gas fumes to keep them from getting into the atmosphere. Could be the evap solonide is not functing or the evap cannister needs replacement. As always if you ae going to work on your own car purchase the Chilton manual or check one out of the library