20 Most Recent 2005 Chevrolet TrailBlazer - Page 5 Questions & Answers

Don't worry about it Unless you see antifrezze spraying out of it its a drain.\ hose

you might have bad teeth on the flywheel or the starter

Alexandre, check in your owners manual for small off button on the shifter under the large engage button. If you do not want traction control on in your vehicle check your manual for traction control fuse location and remove fuse. I can not say this is a wise thing to do, because your traction control is a safety feature for your vehicle. ABS braking system will be lost if you pull the fuse also. Pulling the fuse will disable abs, traction and stability control. Check the attached links,instruction and guides, Good luck "I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info." How To COMPLETELY Disable Traction Stabilitrack Control on GM Chevy Turn Off Traction Control And Stabilitrak 1999 2006 2007 2013 Chevrolet... Traction Control Button

It is likely the radio needs to be pulled out and sent to a factory approved repair center, the parts are not available to the public.

May be the computer model itself. Don't spend big bucks on new one to find out I'm wrong. Go to local junk yard & get one for $30-40 ( if you pull yourself). Pretty easy, just a bolt or two holding in place & a plug or two.
4 Wheel drive model (computer) is different then main computer

Dear hispeed3,

If you haven't bought the part yet and are planning on replacing it ...i'd go to the auto parts store and ask them for the part location. They are usually glad to do this. I know Advanced Auto Parts does this for me.

Are you having a problem with your 2005 Chevy Trail Blazer?
If so...I'm here for you!

jack
Please Rate This!

that thing is in behind ur dash , ur cable might of come off.getting to that thing is a jo.b

Your owners manual will show you that. Similarly, when you take the cover off a fuse box, there is usually a diagram on that cover

You can get an installation kit at an auto parts store that has a connector harness adapter that easily plugs into the vehicle wire harness. It will simplify the installation.

Try using the door key to lock and unlock the drivers door.

The Internet, though, has a large number of web sites where you can buy service manuals and schematics from bookstores, publishers, and other collectors. Here is just a sampling of what sites are out there: Chilton Repair Manuals http://www.chilton.cengage.com/ Haynes Publishing Haynes auto manuals http://www.haynes.com/ Factory Auto Manuals http://www.factoryautomanuals.com/ Vintage Books Vintage books com Rare used and out of print books http://www.vintage-books.com/ AutoLit http://www.autolit.com/home.htm

Have it checked out , don't guess ! Should have a up scale scan tool , professional one hooked up ! Check fuel trims , mass air flow sensor , coolant temp . etc... Crankshaft position sensor ,do fuel pressure an flow testing etc... Your looking for a quick answer , Test ,Test an more testing ! You best bet is take it to a ASE certified repair shop .

Could be the water pump leaking.

p[robably use the scan tool to reset the ECM and it will reset the immobilizer

I would start by replacing the ball joint; the control arm can still be replaced if needed.

code p 128 refers to coolant thermostat---coolant temp below thermostat regulating temperature ====causes --mechanical fault you say that you have replaced the thermostat and it is just under 210 F which is 99 c or almost boiling point you will have to investigate why it is running so hot. check that you put the thermostat in correctly ( bulb section to block/head water Next point --the codes are originated by the coolant temperature sensor ( puts the fans on and sets the ECM fuel/air ratio for the engine ) so to get it off you will need to reset with a scan tool

Ok but you have not posed a question here that anyone can answer. Write a coherent question and you will get a coherent answer.

Have someone check your motor mounts and your shift linkage for wear, binding, and or damage from car accident or from foreign object under the car. Problem should be in one of those areas.