20 Most Recent
1983 BMW 7 Series Questions & Answers
The car wont start it
Sounds more like injectors are stuck open. Pull a spark plug to see if it's wet with fuel. The old 7s have fuel accumulators also that were a common probe on old 7s. I would have BMW look at it to be honest. Their guys have been around these for a long time and know the little intricacies of the older BMWs and they don't just throw parts at a problem. Some specialty shops are good and highly recommended but on something like this, I'd have BMW look at it.
633 csi start shuts of won't idle or rev.
unplug the mass air flow sensor and try to start the car. if it idles, replace it. this can also be done by tps adjustment on the side of the throttle body but can be tricky. let me know
What is a IHKA module and a IDrive screen on a 7 series 745li bmw 2004 and how to fix it
The iHKA is the air conditioning control unit. The panel where you turn on and off the air conditioning and adjust the temperature. The I-drive screen is actually called a CID and it is a control display for all the functions such as navigation, radio, settings, climate control, services due, etc... There really is not a way to fix them without replacement. The control units are programmed to the vehicle and are usually VIN specific and cannot be used from car to car without causing other issues. I have used them temporarily to test a module but never left in or tried coding mine to another model. That makes it hard because you must replace it and that is expensive !!! You can try a used one from a junk yard but most likely will cause new issues
2006 ford fusion solenoid 2 mechanical failure the
solenoids can be replaced with out affecting the transmission
however the burnt oil indicates that the transmission may need a band/ clutch pack adjustment
shifting problems are servo/ solenoids , TR sensor , VSS sensor or the TCM
Not finding what you are looking for?