20 Most Recent 1998 Mitsubishi Montero Sport - Page 5 Questions & Answers


The firing order for the 3.0 engine is 1-2-3-4-5-6

39d8f3b4-6ef6-430f-adef-7eae78758f59.gif

1998 Mitsubishi... | Answered on Jul 10, 2013


replace the turn signal switch in the column, it most likely is shorting out

1998 Mitsubishi... | Answered on Apr 18, 2013


Please confirm to me but I believe the alternator is driven with the serpintine belt. If this is the case there is an idler/tension pulley that would need to be first loosened (I believe it is a 14MM) then at the top of the bracket where this pulley is mounted there is a bolt that you rotate to either loosen or tighten the belt (by turning this bolt you either raise or lower the pulley.
I hope this may have helped,
Tom

1998 Mitsubishi... | Answered on Apr 08, 2013


The Effects of Over Revving a motor can be Catastrophic. I do not understand why the government would require someone to do such a test. Normal Emissions Testing is done at High (2100 - 2500) and the Idle (500-900).

Reason for Increased Smoke.... As you increase the internal pressure of the vehicle, you are creating a VACUUM and this is suckking the Oil past the rings, and anywhere else that it is causing the Vacuum.

Efffects of Over Revving van be Premature Failure of the engine (Could cost you $5-$8,000 to replace)... I would ask WHY so high... A Diesel would MAX OUT their RPM @ 4,000.

These people who are doing the test, ask them to show you where it says in WRITING 4,000... That is much higher than in the 4 states I have been certified to be an I/M Inspector

1998 Mitsubishi... | Answered on Apr 07, 2013


HOLD is located on the shifter, when this is lite up you will only be able to go in gears 1-2

1998 Mitsubishi... | Answered on Feb 10, 2013


You will need a blanket and a flashlight.
One way to get the truck high enough to look under it is to drive either the right side wheels or the left side wheels up onto a curb.
Then get under it and look halfway between the end of the transmission and the rear axle pumpkin.
A carrier bearing is the round thing about half way between these two.
Just a little more information.
The carrier bearing is found roughly about the place where the back of the front seat is above you. The carrier bearing is likely the size of a breakfast cereal bow,l, .
The pumpkin is the big gear holder exactly in the middle between the rear wheels, and is about the size of a large dinner plate.
Your vehicle is old enough to need one if you have not had it replaced yet.
These normally will give you some notice of their failure, such as a vibration or noise of some kind, be not in every case.
Be blessed.

1998 Mitsubishi... | Answered on Feb 01, 2013


If you have no connection on the fuel rail,
then you need to put an adapter in the fuel line
to the motor before the injectors

1998 Mitsubishi... | Answered on Oct 27, 2012


If the check engine light is not on, check the fuel pressure and exhaust flow to start with.

1998 Mitsubishi... | Answered on Aug 28, 2012


what is your question ?

1998 Mitsubishi... | Answered on Aug 05, 2012


the sealer plugs the cores from coolant flow and could also make the t stat stick or you need to look at the reason you put the stop leak in to start with

1998 Mitsubishi... | Answered on Jul 07, 2012

Not finding what you are looking for?
1998 Mitsubishi Montero Sport Logo

433 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Montero Sport Mitsubishi

  • Montero Sport Mitsubishi

Most Popular Question

many quarts transmission fluid needed

  • Cars & Trucks
Loading...