2006 Dodge Durango - Answered Questions & Fixed issues
2006 Dodge Durango 5.7L lightning bolt won't start
If it will turn over but it wont start; try checking the crankshaft position sensor. its on passenger side of the engine close to the front by the EGR valve. If you dont have an EGR valve, (idk which years have them and which ones dont. my Hemi is a 2004 Ram and it does.), then look close to where the head meets the block. (It reads the wheel at the crank.) If that has gone bad, you will most likely get a lightning bolt warning light and it will not start. I keep a spare under my seat so I dont have to pay for a tow. Its one bolt to take out and if I remember correctly you twist the sensor a bit to remove it.
10/30/2021 4:27:21 AM •
2006 Dodge...
•
Answered
on Oct 30, 2021
•
809 views
I have a 2006 Dodge Durango with codes U0125 and C2204 I have tested power and ground and both signal wires there appears to be no issues with the wiring. The esp/bas and Trac control lights are on any suggestions on what to do next. Thanks.
you can get guide from many sites.. i know few
like reliable-store
error codes/ fault codes, wiring diagrams, schematic diagrams, torque specs, engine info, switches functioning, assemble, disassembly, complete refurbish, repair, installation every single thing is covered
within seconds u can get the access and it's totally illustrative complete
2/15/2019 9:01:04 AM •
2006 Dodge...
•
Answered
on Feb 15, 2019
•
387 views
How to drain my 2006 Dodge Durango fuel tank
If the pump will still run, you can open a fuel line, maybe use hose on line to aim down into a container and drain that way. Don't take any lines loose unless your sure no pressure on the system. Sometimes you can get under vehicle remove fill hose from gas tank, then use a siphon hose in the gas tank. Your local auto store probably has a plastic siphon hose, that has a squeeze bulb on it to create a siphon, so you don't have to use your mouth. I don't know if that will reach down the fill tube? In my younger years, they called a siphon hose an okla credit card. I'm almost 70 now, don't like getting gas in my mouth.lol
10/17/2016 9:56:55 PM •
2006 Dodge...
•
Answered
on Oct 17, 2016
•
1,949 views
Tilt wheel stuck I the up postion,How do you fix it
This happens with my ram. The tilt wheel locking pin is stuck. When this happens to me i have to wiggle my steering wheel up and down and pull on the tilt release lever at the same time until the locking pin slides out of it's locked position. I have found that if i do not lock the wheel in the max up or max down position i do not have this problem.
3/10/2016 9:42:32 PM •
2006 Dodge...
•
Answered
on Mar 10, 2016
•
1,666 views
Not finding what you are looking for?