1999 BMW 318 ti - Answered Questions & Fixed issues

Try here https://www.carstereocode.com/unlock.php?id=1126

Replace the back door actuator in said the door,all the best.

Hi Thats you MAF (Mass Air Flow) sensor Replace it and car will be fine. thanks

Try checking or replacing the thermostat.

Don't worry I'm sure you will get the solution of your problem, just check the link I attached Bmw e46

Try this video...shows you how to access the other fuse panel inside your glove box. https://www.youtube.com/watch?v=aJt6uIUII3g

Your description of the problem is not very clear. It seems as if your temp gauge does not work, or does not indicate the correct temperature. If you disconnect the wire from the sensor unit and put it to battery negative (ground), the gauge should move to the full hot position. If this does not happen the best chance is that the gauge does not work. If it does work, the sensor is faulty. In a very unlikely situation, the wire could be faulty..

try here Bimmerforums The Ultimate BMW Forum

throttle sensor fault. might be cleanable if removed. also could be a damaged idle valve, might be staying open this cal also give high revs. and tap and it will go down as its sticking. acceleration is the throttle sensor i may have blank spots. removing it and spraying in the switch breather hole and shake the cleaner around and turning it at the same time should clean the sensor. then shake and leave to drain out the cleaner. idle valve you will need to remove it and clean ti with some carb cleaner and a brush like toothbrush, clean it thorley out push the pin in and out to make sure its not sticking at same time spray it. then when clean leave to dry. then refit them. hope this helps

put water in the car

check battery

unplug battery for 30 mins

your thermostat is stuck in close position change thermostart water is not circulating as thermostat not opening

is the fuse ok? check if the window is still on the runners by taking the inner door trip off

unclip it and clip the new one in

32psi

which one sensor 1 bank to or sensor 2 bank 1

check starter motor or tap the starter with a stick on anything and if it starts then thats the issue

is it manual or auto? any light on dash

AAA or service station or locksmith [that does auto also] advise whoever need to slimjim from passenger side