just a thought is the radio a kenwood if it is ther is yor problam . bmw dashes get verry hot and kenwoods dont like the heat i have had this problem more than once
This just MIGHT help. I hope so.
German cars usually have one item on the route of the serpentine belt that is adjustable.
Traditionally, the way this is adjusted is with a long threaded shaft like a screw, and on that shaft is a lock device to lock the adjustment of the adjusted accessory.
Many times, it is the alternator that is adjustable.
You would loosen the locking clamp, then turn the nuts on the threaded rod, and as you move the part (alternator, for example) towards the engine, the belt will loosen.
Replace the belt and then tighten the nuts and tighten the lock.
God bless your efforts.
the heat exchanger is pierced. oil has a higher pressure, enters in to the coolant sistem, that has a lower pressure. i woul'd change it asap, before the radiator and hoses start to losen theyre ridgidness.
Problems with anti-theft systems using the raised-chip key can prevent the car ... Car Won't Start and Security Light is On how to fix it what 3 min 2 min 1 min start car. Upvote (34). Flag inappropriate ยท 1995 Cadillac Eldorado111,257Visitor .... theft systemtrouble on digital read says theft system problem car may not restart ...
? 17:46
https://www.youtube.com/watch?v=lGhaDwDddf4
Jun 28, 2012 - Uploaded by froggy
I show how to bypass the EWS II security system on a 1995 BMW ... froggy 3 months ago .... not ,what i can .
On vehicles equipped with antilock brakes (ABS), a second warning
light is provided to warn if a problem occurs within the ABS system.
The ABS lamp comes on when the ignition is turned on for a bulb
check, then goes out after the engine starts. If the ABS warning
light remains on or comes on while driving, it indicates a fault
has occurred in the ABS system.
What happens next depends on the nature of the fault. On most
applications, the ABS system disables itself if the ABS warning
light comes on and remains on. This should have no effect on normal
braking. Even so, ABS will NOT be available in an emergency situation
or when braking on a wet or slick surface.
CAUTION: If the brake warning light also comes on and remains
on while the ABS warning light it on, it signals a serious problem.
Your vehicle may not be safe to drive. The brakes and ABS system
should be inspected immediately to determine the nature of the
problem!
If the ABS light comes on momentarily then goes out, the nature
of the problem is usually minor and the ABS system usually remains
fully operational. Some vehicle manufacturers call this kind of
fault a "nonlatching" fault (meaning it isn't serious
enough to disable the ABS system).
Regardless of the type of fault that occurred to trigger the ABS
warning lamp, a special "code" is recorded in the ABS
module's memory to aid in diagnosing the problem. On some vehicles
this code can be retrieved by putting the ABS system into a special
diagnostic mode. The code is then flashed out through the ABS
warning lamp. The code number refers to a diagnostic chart in
a service manual that must be followed to pinpoint the faulty
component. On other applications, a special "scan tool"
must be plugged into the vehicle's diagnostic connector to read
out the fault code.
Hi to remove the fan hub, you will need to lock the pulley still. Bmw have a flat tool that is about 24 inch's long with holes in it that the pulley bolts fit in then turning the spanner against the pulley tool, nut has LH thread so opposite direction. Job done.
I have attached a link to a guide for how to replace the blower motor for your BMW. Note that generally BMWs are referred to in various sites by their internal model code. Your BMW is called an E36.
http://www.dvatp.com/bmw/diy/hvac_blower/
Note that this is a pretty involved process, but you should be able to find parts online.
Bavarian Auto (www.bavauto.com) is a particularly good source for BMW parts.