2001 Oldsmobile Aurora - Answered Questions & Fixed issues
How to bypass security system in 2001 aurora
This is a very common problem on GM vehicles. The security system is known to fail. Basically when you insert your key, the system checks for certain OHMS resistance. If the system cannot get the correct signal from the key, it assumes the key is incorrect and goes into SECURITY lockout mode. (prevents hotwiring) This has been happening with GM;s for a very long time. There are ways to bypass this now. Read through this page for info, solutions as well.
http://www.diy-gm-security.com/
P0305
If the injector is clogged it may cause it to run lean & misfire or the cam or crank sensor is causing a misfire. Have an emissions test, proper fuel pressure readings, live computer readings would give u a head start.
2001 aurora power window/lock failure.
Power Windows Operation
The vehicle is equipped with power windows controlled by the door modules. Each passenger door power window can be operated, either from a switch built into the driver door switch assembly (DDSA), or from a switch mounted locally on its associated door. The driver door power window can only be operated from the switch built into the DDSA.
If the driver door module (DDM) receives a window switch request from any of the window switches built into the DDSA, the DDM checks the Class 2 serial data to see if conditions are correct (i.e. ignition switch position) to permit window operation to occur. If conditions are correct, the DDM, either supplies power and ground to its associated window motor, or sends a command via the power door serial data line to the passenger door module controlling the window. The passenger door module controlling the window then supplies power and ground to its associated window motor to move the window as requested.
When one of the local window switches mounted on one of the passenger doors is operated, the associated passenger door module examines the request and checks to see if there are any messages from the DDM prohibiting the window operation. If conditions are correct, and no prohibitive messages have been received from the DDM, the associated passenger door module then supplies power and ground to its associated window motor to move the window as requested.
Class 2 data network wires under the carpet behind driver seat. Water shorts out the network an and it won't work .
your looking for tan/white wire's and a connector . This is where the problem is .
I am haveing problems with my 2001 aurora
Check dash fuses and relays. You can find fuse box diagrams in your owners manual. Maybe disconected, loose, or damaged connections. Id take it to the dealer and have the dash looked at.
I have a 2001 olds
At the moment, I'm just talking about the front passenger side window. On the hinge side of passenger door, should be wiring harness, probably has protective covering, pull the covering back to expose wire colors. Note the wire colors for battery and ground. Battery is voltage, use a test light, check both orange wires for voltage. You can use to testlight also to check ground, check both grounds. With test light connected to battery voltage, probe the ground wire, both of them, if the lite comes on, at least the ground is good enough to turn on the test light.
Not finding what you are looking for?