20 Most Recent 2003 Mitsubishi Galant - Page 8 Questions & Answers

on thesae oldr cars 2 and 3 cylinder fire together same as 1 aND 4 ,without head under the bonnet i honestly couldnt tell you the answer but i might be inclined to suspect a valve not seating correctly all the time

Some cars/trucks have a heater control valve that cuts off the circulation from the heater core inside the car, look for the 2 rubber hose going into the firewall, follow them and check for an inline valve. If not your coolant might be low or a stuck thermostat. Make sure the water pump is working. I just replaced one on a camry, it was doing pretty much the same thing.

Starter relay is actually mounted on top of the starter. Have you checked to see if your "new" battery was fully charged? If it is, then i would try a new starter which comes with a new starter relay. If you don't think its any of the above, it must be your starter switch. NOTE: starter switch is not where you put the key in, its mounted somewhere on your column, maybe even close to the floor and is actuated with a rod. You can actually start your car without a key after you find where the switch is located. Just pull down on the rod. (little known fact you can start a car without a key this way, hope your not a car theif, you can steal anycar this way lol)

there is usually a diagram on the underside of the fuse box cover, if not then pull them out and check 1 by 1 with the battery disconnected

Hello, Most likely, your problem is your altenator and/or your battery. If possible take your car to the closest auto parts store and they should be able to test it for free. ie: Autozone, Advance Auto, or Pep boys..

It is most likely due to the condesation drain tube being clogged. This tube should drain into the engine compartment. It should be located near the A/C evap. coil area where the refrigerant lines go through the bulkhead. If this tube gets clogged, the condensate will back up and find its way into the passenger compartment

the code you have is for the fuel level sensor-you can access it by taking out the lower back seat -there's a plate that unscrews to access it-check with autozone or pepboys for the parts -cheers Denny

your starter needs replace, for futher assistence please call 4196891712 for 24/7 help

Broken or defective heater blend door or heater blend door motor.

I have a similar problem...when at a stop it jerks in hesitation sometime feeling as if it wants to stall. It also does this when accelerating from stop...it has completely stalled out once when accelerating after switching from reverse to drive, but started right away.

you may have to take it to the dealer to have them reset it

you chock do not working or is block by dirt if is carburetor, you need give more description of car ,model etc

The engine light will come on at 50,000 mile intervals by a pre-programmed setting. If there is nothing wrong with the vehicle, you can reset the light yourself by looking under the dashboard on the drivers side and searching for a small simple tiny switch. Looks just like a typical on off switch and just simply push it to the other side should turn the light off for another 50,000 miles.

check your injectors too. maybe the problem lies there