20 Most Recent
1999 Mitsubishi Mirage Questions & Answers
I got a code po421 on my 99 mits mirage. Brought
It is not true that you have to replace the O2 sensors when you replace the catalytic converter. It is suggested, but not required. Most exhaust shops can test the catalytic converter for flow. before you spend the money to replace a part that does not need it.
Where is the wiper relay on a 1999 mirage?
If you have the owner's manual to you vehicle, its location will be diagrammed in it; otherwise, in absence of your owner's manual, contact the parts department of your local Mitsubishi dealer (or any auto parts store) and they'll tell you its location. Sometimes you may be able to get a copy of the fuse box diagram from the dealership's parts department. Bring the counter-person a coffee to show your appreciation for the freebie!
Remove passenger seat
Seats are usually straightforward to remove though sometimes trim must be removed to access the mounting bolts and usually the seat must be slid right back to access the front bolts and right forward for the rear bolts.
There is usually a few wires to disconnect...
I can't comment about whether your car uses a separate seat and chassis or whether it is integrated.
Trunk is broken.
With the trunk open try putting the key in and turning so that the latch swings open. This may be the problem. The latch may be stuck closed. with the key turned make sure the latch is open if it is not then take a scrwedriver and pry on the latch with the key turned to open it. Then try to close the trunk. I hope this helps. Don't forget to rate my answer. thanks.
Key wont go into ignition
could some thing have been inserted into the ign switch ?if not there is a metal tab that is part of the cylinder lock mechanism which after time and use can break away and stop key going into the barrel,the ign lock barrel will need replacing , will need to be done at a repair shop as need key inserted to remove, so will need a strip down ,a specific technique to remove when key won't go into lock is needed to remove/fit new lock
Not finding what you are looking for?