2006 GMC Envoy - Answered Questions & Fixed issues

Question edited for clarity, wrong type of break vs brake. Question moved to model category. Take it back to the shop. They have a duty of car to fix what you take it in for and not break anything else. Their scan tool should diagnose the issue in 5 minutes. https://www.google.com/search?q=2006+GMC+Envoy+all+the+cluster+light+are+on ..

clogged catalytic converter .

Ck here..... https://www.justanswer.com/gm/7vcpx-06-gmc-envoy-4-2-4x4-has-forward-no-reverse-goes-forward.html

some ideas in the link. It is a ratchet pawl that holds it up. https://www.google.com/search?q=2006+GMC+Envoy+hand+brake+ratchet+not+holding ..

Not familiar with the envoy, but most all GMC trucks have a alarm reset button under the dash by the steering column to reset after battery problems. Why did you change the battery? It may also be your starter has shorted out which will set off the alarm. Good Luck

Hello. Your GMC's oil pump at the bottom of the engine block; covered by the oil pan. To access it; drain the oil and remove the oil pan. The 'oil pickup tube' is bolted to the oil pump 'cavity'. Good luck and keep me informed; if you want to.

CHECK FOR BROKEN WIRE IN HARNESS

I tidied up your question a bit :>) There is a fix here https://www.google.com/search?q=gms+envoy+key+won%27t+open+the+door ..

was it jerking before change out --check installation of unit

The fuel filter on your vehicle is located inside the fuel tank and is part of the fuel pump module. It is, in theory, a lifetime filter and can only be changed by replacing the entire pump module assembly.

I dont believe its used in your situation .

here is a rundown

Car Radio Battery Constant 12v+ Wire: Orange
Car Radio Accessory Switched 12v+ Wire: The radio harness does not provide a switched power source. Run a wire to the fusebox or ignition switch harness for switched power.
Car Radio Ground Wire: Black/White
Car Radio Illumination Wire: Brown
Car Stereo Dimmer Wire: Gray
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): Tan
Left Front Speaker Negative Wire (-): Gray
Right Front Speaker Positive Wire (+): Light Green
Right Front Speaker Negative Wire (-): Dark Green
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Brown
Left Rear Speaker Negative Wire (-): Yellow
Right Rear Speaker Positive Wire (+): Dark Blue
Right Rear Speaker Negative Wire (-): Light Blue

The BEST Way TO Perform Parasitic Draw Test

Dave, good news for you. There is a recall for the master switch on the drivers door. The recall involves water being able to get into the switch. I wouldn't say anything, just call and ask about the the recall. This "module" is the switch itself. Pop the plastic trim upwards, the switch comes right up.

Hello, Janice - I can only think you do not have the owner's manual for your vehicle. The information about turning the curb view assist mirror on and off can be found in the manual. This is the link to the PDF format user's manual for the 2006 GMC Envoy: https://my.gmc.com/content/dam/gmownercenter/gmna/dynamic/manuals/2006/gmc/envoy/2006_gmc_envoy_owners.pdf You will need Adobe Acrobat Reader software (free) to download/save the manual. If you download and save the manual to your Documents folder, be sure to save it using a file name you can find again easily, something like: GMC Envoy 2006 Manual. The instructions to turn the Curb View off is on page 3-64 (Image 208) of the manual. Best wishes.

Mirror Tilt in Reverse Controls This feature is capable of tilting the passenger side power mirror when the transmission is placed in reverse to provide enhanced visibility during parking or backing maneuvers. This feature is turned OFF or ON through the DIC. The passenger mirror on domestic vehicles can not be changed from the factory setting, but on export vehicles, the passenger mirror position may by changed using the same procedure as the driver mirror. For further information, refer to Driver Personalization in Personalization. Tilt Mirror In Reverse Continue with the following steps in order to personalize the tilt mirror in reverse. Press the Select button in order to enter the menu. The first choice seen is the current setting. Press the Select button in order to scroll through the following options: • CURB VIEW: OFF (Default) • CURB VIEW: PASSENGER Press the Personalization button in order to advance to the next option.

It's part of the mass air flow sensor ,

Here is for the 4.2l ENGINE

A rod problem is a steady knock which increases with rpm. More likely you have a plugged air filter , a plugged fuel filter or a vacuum leak, ( vote fuel filter , people never change those often enough)

the release at the bottom of hatch can be ---rusted normal in northeast --- linkage popped or broken --linkage clip popped or broken --- need to crawl into back and remove the plug [ lower center of rear hatch panel will need a long screw driver and light will see linkage and latch push down on linkage arm and push open hatch when opened you can remove the rear panel and assess the problem but lube the latch and upper window latch

With as many sensors as that thing has, go to Autozone and ask for a free diagnostic tool check.