2000 BMW 5 Series - Answered Questions & Fixed issues

You can find the procedure here https://resetoillight.com/bmw/oil-change-light-reset-bmw-528i-1998-1999-2000/

Try the starter terminals.

Open door panel and remove glass from mechanism and check for movement independently to identify the problem.

Have a go at fixing yourself. This video will give you an idea of what is involved. It could cost you nothing! search "comeinhandynow window regulator"

First, replace the radiator or expansion tank cap. Also excessive steam and the smell of burnt anti-freeze are a sign of a blown head gasket, as is water in the crank case.

As you apply the brakes the rotar and the pads wear down and your flued level goes down also, if you keep going the pads will drop out and the rotar will also get thiner the pads will actually fall out and you will have no brakes at all, so it is advisable to replace the pads it will cost you less money in the long run.

Blue indicates a lot of engine oil is being burned, black would mean too much fuel, and white would mean excess water/coolant. Being as it's blue, it could be any one of a number of things, all internal in the engine. Could be bad oil rings, valve guides, stem seals, etc. I suggest an engine shop to properly determine the cause. Might just be a plugged pcv system that just needs cleaning, you never can tell from the outside. Is there a lot of oil in the air cleaner assembly? If with the engine running, you carefully remove the oil fill cap, is there a lot of pressure/gasses escaping? There shouldn't be.

Check the current draw when the car is switched off. if it is not obvious whet is staying on, remove fuses one buy one and see when the current draw goes down. Note that the car does not go to "sleep" until something like 16 minutes after you turn off the engine.

dont put engine oil into a transmission you will destroy it ---automatic transmissions use a fluid --transmission fluid ---manual transmission use a different lube --- consult with your manual or dealer for what to use to fill it ...

The oil must be in full level.. Try to repair 1st the leak of trans and change the trans oil at The same time..

experiencing any warning lights?

Possible low freon, glitchy compressor relay or bad clutch

I know this is an old thread, but my 2006 325i Nav screen went bank also, but the radio still played. I noticed the glove box light and trunk light did not turn on also. I was told from mechanics is was probably a CID module for $2200, even though I mentioned the glove box and trunk light light were out and specifically inquired about a fuse. The mechanics never checked the fuses, because I checked my fuses in the glove box and found the fuse 61 marked with a BMW symbol that looks like light bulb was blown. The Nav screen started back up once the fuse was changed.

could be bad pump,or hose's or could be rack&pinion seals if seals try Lucas rack&pinion stop-leak,& re-conditioner ,

the abs has nothing to do with brake pads. the abs runs on speed sensor on each tire. if your brake light is on all bmw have a wire in the brake pads for warning the brakes are low

Have your thermostat checked, sound like it is not working when cold.

yes ! i wd sell it / trade but u wont gt what its worth

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help. Thanks.

Check the front stablizer links?

Hello and welcome to FixYa!
As a first course of action, I strongly suggest that you remove the positive battery connector and let it sit for atleast 5mins. before reconnecting. This will reset the system and may get rid off the light.
If problem still persists, I suggest that you have it resetted by a scan tool manually.
Hope this helps and thank you for using FixYa! Have a good one!