20 Most Recent 2006 Mazda MPV - Page 7 Questions & Answers

Need to know year make and model

this is a dealership only code, sorry. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/stephen_171aeeebef53a898

It appears from a wiring diagram that there is no ignition control module. The ignition coils' primary circuits are grounded through the PCM. And the wires to the sensors are all from the PCM. Here is a link if you want to see all your wiring diagrams. I found the above information under System: engine; Subsystem: fuel controls. Free wiring diagrams and TSB's for every make and model: http://www.bbbind.com/technical.html

If you are sure the computer is the problem... remove the original one and it will have a tag on it with part numbers. Find one at a salvage yard and compare part numbers to make sure they are the same and it should work. The only thing that may cause issues is if the vehicle has a security system and a relearn/reprogram may be required

Check cylinder compression and post results.

Spark is controlled by the ignition control module. There's where your problem is.

If this is a High Mileage Vehicle The Transmission Has FAILED and Needs to Be Replaced

First, check to see if all spark plug wires are firmly attached. If they are, then look at or replace your spark plugs. If you have a testor, see if all spark plug wires are working well.

I would check to see if the brake light switch is stuck.

Usually at the bottom of fluid tank, feel underneath it for wire going to are located at bottom of tank. I have never seen a pump located anywhere else but on bottom of tank. CeraCoat-NanoTech.com

power steering is electric controled. check wiring. .

yes do a restore and change it there . look on youtube

remove inner panel look for hidden screws panel may have pop out clips so pull at panel gently should be 2 10 mm nuts that hold it in pop up clip pull out handle rod etc.

NECESITO COMO PONER LA CADENA DE TIEMPO DE UNA MAZDA MPV DEL 95

CHCK FUSE OR RELLEY.

check for dirty plugs,and rotor arm and distributor cap ,all may need cleaned.