20 Most Recent 2005 Mazda RX-8 Questions & Answers

it could be a lot of things.. but if you smelled something burning then you may have already done damage to your car. id have it towed to a dealer.

the key should have been programmed to your vin /vehicle also

Which pulley? Timing belt...

The first thing you need to do is have the electronic engine control system scanned for fault codes, this is called an "OBD2" fault code test.

does not exist for free you have to buy one

is the hazard switch damaged or dont know where that is also --this is a copy of your owners manual 2005 Mazda RX 8 Manuals

In the injector pump,it's a switch with a wire running to it.

If you didn't have a miss before, then I would suspect the new plugs or wires. Just use your old ones to replace them one at a time. The new O2 sensor shouldn't create a miss even if it wasn't working. (Not only that, you'd shortly get a check engine with the O2 code.)

Could be many things. A relay, fuel pump, coil, and so on. You would need to figure out if you are missing spark or fuel to know which system to test.

is it possible you left a light on in the car?
is it making any noise or its cranking just not starting or is it making a fast ticking noise?

Search Results

1. images for 2005 mazda rx 8 wiring

when you turn the ignition pump the clutch twice so the fuel pump doesnt inject fuel and hold the ignition till it starts dont turn it back just hold it

Replace the switch. Th contacts on the inside are worn and bent from heat. Take it apart and try to fix it. I fix them and a lot of other switches. Some times a tab needs bent a little, sometimes they need cleaned with fine grit sandpaper. It's already broke, what are you going to do, break it more?

that would be spark plugs fuel and or air problem if it runs good otherwise

What are you asking?

3rt time or 4th do we get 5?